Microchip Technology Inc.

Philippe Gimmel

Philippe Deval

John R Austin

Scott Dearborn

Terry L Cleveland

Thomas Youbok Lee

Yann Johner

Daniel Leonescu

Jonathan Jackson

Marius Budaes

Tim Sherman

A high voltage switching regulator has significantly reduced current sensing delay between measurement of input current and generation of sensed current values, while maintaining good accuracy of the current through a power transistor using current replication and a current conveyor. High sensing accuracy of the input current ensures good load regulation, and low sensing delay ensures fixed duty cycle over a wide range of output currents and high input to output voltage ratios. A current conveyor is used to transfer high side current values to low side control circuits, e.g., pulse width modulation (PWM) control. The current conveyor is always on, e.g., some current flow is always present, thus minimizing any current measurement delay. This is accomplished by dynamically biasing the current conveyor by draining to ground a current equal to the sensed current. Wherein balancing of the current conveyor is ensured and offset at the input of the current conveyor is minimized.

Effective current sensing for high voltage switching regulators

A mixed signal integrated circuit device, e.g., digital-to-analog converter (DAC), has a serial interface communication protocol that accesses volatile and/or non-volatile memory and allows a preprogrammed output voltage whenever the mixed signal device is powered-up. However, unlike conventional DACs, DACs with non-volatile memory may need special interface communication protocols for effective operation of the DAC and communications between a system master controller unit (MCU). Interface communications protocols that do not violate standard serial bus communications protocols are provided for communicating between the volatile and non-volatile memories of the DAC so that the MCU may access the DAC's memories (non-volatile and/or volatile memories). The mixed signal integrated circuit device has a user programmable address.

Read and write interface communications protocol for digital-to-analog signal converter with non-volatile memory

Growing community of inventors

Lausanne, Switzerland

Philippe Gimmel