Seagate Technology Incorporated

Peter R Riegler

Anthony Joseph Aiello

Klaus Dieter Kloeppel

Alan Lyndon Grantz

Mohamed Mizanur Rahman

Roger Allen Addy

Samnathan Murthy

Steve Parsoneault

A shaft having a thrust plate at or near one end, and a sleeve cooperating with the shaft to define one or more journal bearings and a counterplate (which may be supported by the sleeve or defined by the sleeve) defining at least one counter thrust surface in cooperation with the thrust plate. In order to maintain an enhanced fluid distribution across the journal bearing and maintain pressure distribution boundary conditions as desired, one or more grooves are defined along the shaft extending behind or between the thrust plate and the shaft. The grooves typically extend from one radial side of the thrustplate behind the thrustplate and up to a point on the shaft adjacent or nearly adjacent to one of the journal bearings. Alternatively, the slot or slots may extend to a point between two journal bearings. In this way, the pressure from the distal axial surface of the thrust bearing to the point where the slot terminates is equalized, enhancing the stability of the boundary conditions over each of the journal bearings and equalizing the pressure at the opposite ends of the fluid distribution slot.

Single plate hydrodynamic bearing with self-balancing fluid level and fluid circulation

A hydrodynamic bearing useful as a bearing cartridge or as the cartridge may be incorporated into a spindle motor or the like, where the bearing includes a stationary shaft and two independent bearings, comprising a top cone and a bottom cone separated by a segment of the shaft. The bearing includes a sleeve rotating around and surrounding the shaft, and the top cone and bottom cone and defining a narrow gap between the sleeve and the shaft and cones. Sealing plates are supported on the sleeve to seal off the ends of the bearing and are located along the shaft beyond the cones. A gap also exists between an interior surface portion of each cone and the shaft. Thus, separate flow paths are established, one around the top cone and one around the bottom cone. By providing two independent paths, the flow rates do not have to be the same in each conical flow path for the bearing seals to function properly.

Simplified conical bearing with independent flow paths

Growing community of inventors

Coronado, CA, United States of America

Peter R Riegler