Cardiac Pacemakers, Inc.

Data Sciences, Inc.

Perry A Mills

Brian P Brockway

Robert D Dreher

Thomas C Wright

Daniel E Huntwork

Brock S Lindstedt

Thomas G Wallner

Terrence R Hudrlik

Jonathan T Miller

Robert C Rust

Douglas C Morrison

Measurement of a physiological pressure is accomplished by placement of a pressure transmitting catheter within a blood vessel or other structure within which pressure is to be measured. The catheter is blood-compatible, capable of withstanding handling during distribution and implantation, and provides adequate pressure transmission frequency response in a variety of applications. The catheter, which includes a hollow flexible tube filled with a low viscosity fluid and having a plug of a gel-like material at its distal end, transmits the pressure signal to a solid-state transducer which is typically connected to amplifying electronics and an implantable radio-transmitter capable of relaying the pressure information from within the body to a radio receiver located external to the body.

Device for chronic measurement of internal body pressure

A device capable of sensing pressure allows the sensor and amplifying electronics to be packaged in a very small size and implanted within the body. The sensor consists of a small catheter, the tip of which is placed at the point at which pressure is to be measured, attached to a solid-state pressure sensor. The catheter is filled with a fluid and is connected to an implantable infusion pump which dispenses through the lumen of the catheter, heparin or other drug which inhibits thrombogenisis.

Device and method for chronic in-vivo measurement of internal body

A telemetry system includes a transmitter, which is either placed in the vagina or is implanted in the vulvular or vaginal tissue, and a receiver. The transmitter is capable of measuring physiological parameters which are indicative or predictive of the occurrence of estrus. These parameters may include but are not limited to tissue impedance, temperature and activity of the animal. This provides a pulsed method of measuring impedance of vulvular or vaginal tissue which enhances the marketability of such a device by reducing its size, weight and complexity without sacrificing accuracy or reliability. Data telemetered from this device is preferably collected by a computer and automatically analyzed to provide a report to the farm manager as to which animals are in estrus or are expected to be in estrus at a given time.

Device for automated detection of estrus in farm animals

A programmable cardiac pacemaker that is selectively programmable via a radio frequency communications link into one of a plurality of a single and dual chamber pacing modes. Depending upon the mode selected, an associated plurality of pacing parameters may be programmed, each within a predetermined range of possible magnitudes. The pacemaker includes a rate smoothing function for preventing the rate interval from changing by more than a predetermined percentage on a cycle-to-cycle basis; and a graceful degradation function for causing the ventricular pacing rate to decay when the atrial rate exceeds a programmed upper rate limit for a predetermined length of time. A graceful degration onset time and rate of decay are also programmable. Additionally, the pacemaker contains a set of pre-programmed alternative pacing parameters for at least one mode and which can be independently reverted to. The pacemaker control circuitry is organized about a central bus into an I/O controller and a pacing controller. Pacing control is continuous and its I/O communications operate on a prioritized basis. I/O control permits the programming of any register and the interrogation of a variety of analog parameters associated therewith.

Programmable multi-mode cardiac pacemaker

A sensing circuit for a cardiac stimulator which can adapt to the use therewith of either bipolar leads or unipolar leads without the need for telemetric programming of a switch internal to the implanted pacemaker. If a unipolar lead is plugged into the terminal receptacle of the pacer at the time of implant, the pacer will sense R-wave activity and other artifacts between a distal tip electrode and the metal body of the pacemaker, but if a bipolar lead is plugged into that same receptacle at the time of implant, the pacer will sense such artifacts between a tip electrode and a ring electrode spaced a predetermined short distance proximally of the tip electrode along the surface of the lead body.

Pacemaker with adaptive sensing means for use with unipolar or bipolar

An electrical pacer device which responds to cardiac demand so as to alter the cardiac output in a fashion to satisfy that demand. Changes in the fundamental period of the atrial electrical cycle are detected and averaged over a predetermined time interval and the resulting control signal is used to raise and lower the ventricular heart rate to increase and decrease the aforesaid cardiac output. At the same time, means are provided for continuously driving the ventricular rate toward a predetermined lower rate (the at rest rate) on a time cycle which is significantly longer than the above-mentioned predetermined time interval.

Growing community of inventors

Roseville, MN, United States of America

Perry A Mills