Huawei Technologies Co., Limited

Crrc Xi'an Yongejietong Electric Co., Ltd.

Pengbo Tian

Liang Jie Xu

Songlin Li

Qingyun Wang

An Huang

Liang Xu

Lungang Yun

Xiaojun Hou

Caixia Zhang

A power tube connection structure includes a substrate, a printed circuit board, and a power tube, where a through groove allowing the power tube to pass through is cut into the printed circuit board, a mounting groove is cut into the upper surface of the substrate at a location corresponding to the through groove, one end of the power tube extends through the through groove, and is welded onto a bottom face of the mounting groove, the end of the power tube that extends into the mounting groove abuts onto a side wall of the mounting groove close to an output end of the power amplifier, and a solder flux escape channel is made into the side wall of the mounting groove close to the output end of the power amplifier.

Power tube connection structure of power amplifier and power amplifier

Relating to electronic components, the present disclosure provides a method for welding a gold-silicon eutectic chip, and a transistor. The method for welding a gold-silicon eutectic chip includes: electroplating a gold layer with a thickness smaller than or equal to 1 micron on surfaces of a chip carrier; bonding multiple gold protrusions on the gold layer in a welding region; and rubbing a chip in the welding region at a eutectic temperature to form a welding layer. The transistor includes a chip, a chip carrier, and a middle layer connecting the chip and the chip carrier, where the welding middle layer is a welding layer obtained by using the above welding method. The present disclosure reduces an amount of gold in use and lowers a cost of gold-silicon eutectic welding to a relatively large extent, and, accordingly, cuts down the cost of a transistor.

Method for welding gold-silicon eutectic chip, and transistor

Growing community of inventors

Xi'an, China

Pengbo Tian