Richtek Technology Corporation

Raydium Semiconductor Corporation

Pei-Kai Tseng

Chien-Fu Tang

Issac Y Chen

Isaac Y Chen

Jyun-Che Ho

Chih-Jen Hung

Shen-Xiang Lin

Kuang-Feng Li

Chen-Pin Lo

Li-Chieh Chen

A charge pump, applied to an OLED display panel and coupled to an output capacitor, includes a first switch to a tenth switch and a first capacitor to a third capacitor. The first switch and second switch are coupled in series between a first voltage and a second voltage lower than first voltage. The third switch is coupled to second voltage. The sixth switch is coupled to first voltage. The seventh switch is coupled to second voltage. The fourth switch, eighth switch and tenth switch are coupled to output capacitor. The first capacitor is coupled between first switch and second switch. The second capacitor is coupled between fifth switch and sixth switch. The third capacitor is coupled between seventh switch and eighth switch. The charge pump is operated in a first phase, a second-A phase, the first phase and a second-B phase in order to provide negative output voltage.

Charge pump applied to organic light-emitting diode display pane

A charge pump circuit includes a first switch&#x2dc;a fourth switch, a capacitor, a current source, a first resistor, a second resistor, an amplifier, another current source, a current mirror, a skip detection circuit, a switch generation circuit and a control unit. A method includes: (a) starting the charge pump circuit; (b) operating the charge pump circuit in a first phase, wherein the first switch and second switch are conducted and the third switch and fourth switch are disconnected; (c) operating the charge pump circuit in a second phase, wherein the third switch and fourth switch are conducted and the first switch and second switch are disconnected; (d) determining whether a detected voltage in the skip detection circuit is higher than a threshold voltage; and (e) selectively performing step (b) or (c) again according to determination result of step (d).

Charge pump circuit and operating method thereof

A floating gate driver uses a single-end level shifter to translate a set signal and a reset signal induced by a rising edge and a falling edge of a switch signal to a common output terminal to generate an output voltage for a bistable circuit to generate a level shifted switch signal. Under control of a well transient detect signal asserted by detecting noise in the output voltage, a masking circuit between the single-end level shifter and the bistable circuit masks noise in the output voltage. This configuration has lower area penalty and better noise immunity.

Circuit and method for improving noise immunity of a single-end level shifter in a floating gate driver

A high voltage half-bridge driver circuit has a high voltage terminal and a floating node to be connected with a high side switch therebetween. When turning on the high side switch, a high voltage offset detection circuit detects a voltage related to the voltage at the floating node for triggering a zero voltage switching signal.

High voltage offset detection circuit

A floating gate driver circuit includes a level shifter, a pass element, a bistable circuit and a control logic circuit, to shift the voltage level of a control signal from a lower one to a higher one. The level shifter or the pass element has loads dynamically controlled by the control logic circuit to filter malfunction caused by dv/dt noise induced by a floating node.

Configuration and method for improving noise immunity of a floating gate driver circuit

A high voltage H-bridge driver circuit has a high voltage terminal and a floating node to be connected with a high side switch therebetween. When turning on the high side switch, a high voltage offset detection circuit detects a voltage related to the voltage at the floating node for triggering a zero voltage switching signal.

Growing community of inventors

Keelung, Taiwan

Pei-Kai Tseng