Transwitch Corporation

Pawan Goyal

Kumar Shakti Singh

Daniel C Upp

Vikas Kumar

Arnab Basak

Edward Soltysiak

The excessive bit error rate detection algorithm operates in two modes: BURST mode and non-BURST mode. In non-BURST mode, an alarm state is entered if an error count exceeds a threshold within a set number of frames and exits the alarm state when the error count stays below a threshold for a set number of frames. In the BURST mode, the alarm state is not entered unless the error count exceeds the threshold two consecutive times and does not exit the alarm state unless the error rate remains below a threshold for two consecutive frame counts.

Methods and apparatus for burst tolerant excessive bit error rate alarm detection and clearing

Methods for retiming and realigning SONET signals include demultiplexing STS-1 signals from an STS-3 signal, buffering each of the three signals in a FIFO, determining the FIFO depth over time, determining a pointer leak rate based in part on FIFO depth and also based on the rate of received pointer movements. For a 28-byte deep FIFO, if the depth of a FIFO is 12-16 bytes, no pointer leaking is performed. If the depth is 0-4 bytes, an immediate positive leak is performed. If the depth is 24-28, an immediate negative leak is performed. If the depth is 5-11 bytes a calculated positive leak is performed. If the depth is 17-23 bytes, a calculated negative leak is performed. The calculated leak rates are based on the net number of pointer movements (magnitude of positive and negative movements summed) received every 32 seconds (256,000 frames).

Growing community of inventors

New Delhi, India

Pawan Goyal