Stmicroelectronics International N.v.

St-ericsson Sa

Ondrej Tlaskal

Matthieu Thomas

Bohumil Janik

Patrik Arno

Vladimir Molata

An electronic device includes first and second transistors coupled in series between first and second source voltage levels. An inductor is coupled between a node coupling the first and second transistors and a load. Control logic is operative to generate control pulses operative to switch the first and second transistors. The controller generates the control pulses as a continuous stream of control pulses in a continuous conduction mode, and skips generation of some control pulses in a discontinuous conduction mode in response to a pulse skipping signal. A pulse skipping circuit is operative to generate a sense voltage as a function of an inductor current in the inductor, compare the sense voltage to ground, and generate a pulse skipping signal to the control logic when the sense voltage is below ground.

DC-DC switching converter with enhanced switching between CCM and DCM operating modes

A DC-DC converter transitions between continuous conduction mode (CCM) and discontinuous conduction mode (DCM) without causing any overshoot or undershoot deviation output voltage. The DC-DC converter operates in a PWM mode in CCM. During DCM, it skips PWM pulses when a sustained negative current is detected in an output inductor. The current sensing is achieved by sampling and integrating a voltage, the sign of which is inverse to current direction. The sample and hold and integrator circuits are small, simple, and scale to high frequencies. The pulse skipping circuit automatically adjusts the duty cycle of power pulses to force a zero inductor current at the end of each pulse.

DC-DC converter with enhanced automatic switching between CCM and DCM operating modes

A power conversion circuit uses smaller, cheaper, and faster analog and digital circuits, e.g., buffers, comparators, and processing circuits, to provide the information necessary to control a multilevel power converter faster, cheaper, and with a smaller footprint than conventional techniques. For example, a current detection circuit indirectly measures a direction of a current through an inductor connected between midpoint node and an output node of a multilevel power converter based on comparisons between voltages associated with the multilevel power converter. A capacitor voltage detection detects a capacitor voltage across the flying capacitor to generate a logic signal based on a comparison between the capacitor voltage and a first reference voltage. A control circuit selects an operating state of the multilevel power converter to regulate a first capacitor voltage across the first capacitor based on the indirectly measured direction of the inductor current, the logic signal, and an input command signal.

Growing community of inventors

Kamenice, Czechia

Ondrej Tlaskal