Snecma

Nicolas Marie Pierre Gueit

Franck Godel

Julien Marcel Roger Maille

Benoit Pontallier

Antoine Olivier François Colin

Catherine Dorothée Josette Ibanez Garcia

Benoît Pontallier

A method for monitoring at least one locking device of an electrical thrust reversal system for a turbine engine, the method being carried out by a computer prior to the take-off of the turbine engine, the method including sending a command for opening the locking devices; verifying the opening of the locking devices; sending a command for closing the locking devices; and verifying the closing of the locking devices.

Method for monitoring the locking means of an electrical thrust reversal system for a turbine engine

After the control system has been started, which system has two control paths that are used as alternatives for delivering a control electric current to an electrohydraulic member for transforming said current into hydraulic power that is delivered to the actuator, and before powering a starter-generator of the engine, the detection method comprises implementing the following steps for each of the control paths in succession:

Method and a device for detecting an electrical failure affecting an electric control system of a hydraulic actuator of variable geometries of an aeroengine

A device and method of monitoring the measurement of a fuel flow rate fed to an airplane engine includes delivering the measurement from a mass flowmeter. The monitoring also includes evaluating whether at least the following conditions are satisfied: a signal delivered by the flowmeter is less than a given value; and the engine is running on its own. The measurement is invalidated if these conditions are satisfied simultaneously.

Method and a device for real time monitoring of a system for measuring a fuel flow rate

A method for monitoring a system for actuating variable geometries of a turbojet engine, the actuation system including a control device, a servovalve, and an actuator controlled by the servovalve, the control device configured to determine a control current according to a set position value and to a measured position of the actuator and to provide the control current to the servovalve. The monitoring method includes: detecting a stabilized condition; determining an average value of the control current during the detecting the stabilized condition; and comparing the average value with a predetermined threshold.

Method and device for monitoring a servovalve actuation system

In a testing overspeed protection system: a) on receiving an order to start a turbomachine, an electronic regulation system (ERS) of the turbomachine sends an order to a control circuit of a fuel cutoff member to close the fuel cutoff member or to keep it in the closed position; b) the closed state of the FCM is verified on the basis of information transmitted to the ERS and representative of the position of the FCM; c) if the result of the verification in b) is positive, the ERS sends an order to the FCM control circuit to authorize opening of the FCM and enable the starting procedure to continue; and d) if the result of the verification in b) is negative, the ERS issues fault information concerning the overspeed protection system.

Growing community of inventors

Paris, France

Nicolas Marie Pierre Gueit