Hyundai Motor Company

Kia Motors Corporation

Min-Kyu Han

Jung-Suk Han

Dong-Hoon Lee

Hyeok-Jun Kwon

Tae-Gon Noh

Kyung-Ho Ahn

Kyong-Duck Park

A method of controlling an air-fuel ratio in a pre-ignition (PI) situation, may include: monitoring, by a PI detector, whether PI occurs in a cylinder of a plurality of cylinders of an engine; and when the PI occurs in the cylinder of the plurality cylinders, controlling, by a controller, an air-fuel ratio of the cylinder in which the PI occurs to be smaller than a theoretical air-fuel ratio, and controlling an air-fuel ratio of a remaining cylinder of the plurality of cylinders in which PI does not occur to be larger than the theoretical air-fuel ratio.

Control method and system of air fuel ratio in pre-ignition situation

A method for improving engine start performance of a vehicle performing engine synchronization at the time of the engine start may include performing a first synchronization task from an engine stop position stored when the engine stops in immediately previous traveling, and performing the first synchronization task when a crank signal of a crank sensor is first input to an engine position management (EPM) module.

Method for improving engine start performance of vehicle

A method of resuming multi-port injection using an intake stroke of an engine includes performing a first refueling with immediate start of ignition injection at the time when an injection abortion angle does not pass through an intake stroke, when injection is determined to be resumed after coasting by a controller. The method can minimize an engine RPM drop caused by the early generation of torque. The method improves fuel efficiency while being advantageous to calibration of the engine by setting the engine RPM to be low at the time of fuel cut-in.

Method of resuming multi-port injection using an intake stroke and a vehicle using same

A method for controlling a plurality of injectors installed in the same cylinder of an engine may include determining whether an electrical failure occurred in any of the injectors, and entering a fail-safe mode when an electrical failure has occurred only in one of the plurality of injectors in the same cylinder. In the fail-safe mode, fuel supply to an injector that has experienced an electrical failure is cut off, and the amount of fuel injected into the cylinder by a normally operating injector is increased.

Control method for dual injector of engine

A fuel amount distribution method is provided to distribute fuel to a plurality of injectors on each of multiple cylinders of an engine with a dual injector. The fuel amount distribution method includes performing, by a controller, a single injection operation in which a single injector of the plurality of injectors constituting the dual injector injects fuel into a corresponding cylinder when a required fuel injection time of the dual injector of at least one cylinder of the multiple cylinders is less than a minimum injection time of each injector of the plurality of injectors of the dual injector. Thereby, precise air-fuel control in a low fuel rate section is achieved.

Fuel amount distribution method for an engine with a dual injector

A method for correcting an injector characteristic defining a relationship between an injector injection time and a valve closing time for a cylinder of an internal combustion engine by sensing an injector closing time includes steps of: sensing the injector closing time; determining a compensation amount for compensating for a commanded injection time using a number of sensing failures or a result of a learning of a relationship between a required commanded injection time and the injector closing time in a relevant cylinder, in addition to the number of sensing failures when there is a failure to sense the injector closing time; and controlling a commanded injection time according to an amount of required fuel injection in the relevant cylinder, based on the determined compensation amount.

Growing community of inventors

Hwaseong-si, South Korea

Min-Kyu Han