Kingston Technology Corporation

Mike Chen

Ramon S Co

David Sun

A manufacturing method makes memory modules from partially-good DRAM chips soldered to its substrate. The partially-good DRAM chips have a number of defective memory cells that is below a test threshold, such as 10%. Packaged DRAM chips are optionally pre-screened and considered to pass when the number of defects found is less than the test threshold. A defect table is created during testing and written to a serial-presence-detect electrically-erasable read-only memory (SPD-EEPROM) on the memory module. The memory module is finally tested on a target-system tester that reads the defect table during booting, and redirects memory access to defective memory locations identified by the defect table. The memory modules may be burned in or tested at various temperatures and voltages to increase reliability.

Manufacturing method for partially-good memory modules with defect table in EEPROM

A downgraded memory module has downgraded DRAM chips soldered to its substrate. The downgraded DRAM chips have a defective memory cell in a logical quadrant of the memory. A physical MSB is a row address present on a non-downgraded DRAM of size S but not used on a downgraded DRAM size S/2. The physical MSB and a second address pin are non-multiplexed address pins that do not carry column addresses. The physical MSB and the second address pin logically divided the DRAM into quadrants. Two good quadrants without defects are selected, and jumpers on the memory module drive the physical MSB and the second address pin with signals that select only these two quadrants and disable access to quadrants containing defects. DRAM chips can be marked or sorted into bins for combinations of good quadrants. Downgraded memory modules have all DRAM chips from the same bin that share jumper settings.

Growing community of inventors

Newport Coast, CA, United States of America

Mike Chen