USA As Represented by Secretary of the Navy

The Penn State Research Foundation

Michael J Beam

Allen L Treaster

Alberico Menozzi

Carl Gerard Schott

Daniel P Thivierge

Richard E Dooley

Daniel Metrey

Timothy A Brungart

Todd K Fetterolf

The mechanism of the present invention maneuvers a vehicle by deflecting the flow from a propulsor of the vehicle. The mechanism has an elastomeric nozzle that encases the flow and is deflected via an articulation device mountable inside the vehicle. The nozzle is shaped and supported by spiral-wound composite to maintain a circular cross-section through a range of motion. An end of the nozzle is attached to the shroud of the propulsor and another end is supported by a ring with support struts radiating from a hub. The hub is supported by a shaft attached to a gimbal. The gimbal is constrained in movement by an outer race and an anti-rotation stud in a radial slot in a ball of the gimbal. A linkage as part of an articulation device controls rotation of the gimbal to direct movement of the shaft and enclosed nozzle thereby deflecting flow of the propulsor.

Articulation mechanism and elastomeric nozzle for thrust-vectored control of an undersea vehicle

A tunnel thruster which is compact, quiet and can withstand the higher depth pressure encountered by a UUV. The UUV is usually a cylindrically shaped vessel and has a propulsor with control surfaces at one end. At two positions along the length of the body there are two cylindrical ports which pass through the body of the UUV. At each position one port is in the vertical plane while the other port is in the horizontal plane. These ports are four tunnel thrusters, which enable the maneuvering of the UUV. The tunnel thruster can be mounted in the ports of the UUV. The main components of the tunnel thruster includes a tunnel, motor assembly mounted in the tunnel, rotors on each end of the motor assembly and inlet ducts on each end of the tunnel. The tunnel thruster attempts to address the short comings of the commercial thrusters. The tunnel thruster is an all electrically powered thruster with all mechanical components contained within the tunnel. The rotors operate independently and are counter-rotating. Each rotor is directly driven by its own electric motor. The rotors are held in position by water lubricated fluid film journal and thrust bearings. The rotor duct assembly includes the rotor, inlet duct, bearing and seals, which can be used in other applications.

Tunnel thruster and water lubricated rotor duct assembly

Growing community of inventors

Tyrone, PA, United States of America

Michael J Beam