Siemens Aktiengesellschaft

Maximilian Engl

Manfred Wier

Anton Angermaier

Stefan Treinies

Gerd Rosel

Hong Zhang

Klaus Bayerle

Stefan Schneider

Hartmut Pfleger

Willibald Schuerz

Johann Froehlich

Johann Frohlich

Willibald Schurz

A setpoint torque is determined from a torque factor, a maximum torque and a minimum torque. The torque factor is derived from a pedal value and a rotational speed. The maximum and minimum torques are determined as a function of the rotational speed, a loss torque and engine performance parameters. The loss torque is determined as a function of the rotational speed and the performance parameters.

Method for controlling an internal combustion engine

A diagnostic device for monitoring an exhaust gas recirculation system determines a diagnostic value of the exhaust gas recirculation system without influencing the operation of the internal combustion engine. The diagnostic value depends on the intake pipe pressure and an observer intake pipe pressure. The latter is determined by an observer from one or more further operating variables of the internal combustion engine. The diagnostic device determines that the exhaust gas recirculation system is defective when the diagnostic value lies outside a range of values that depend on at least one operating variable.

Diagnostic device for monitoring an exhaust gas recirculation system of

A method for calculating an actual fresh-air mass flowing into a cylinder with the aid of an inlet pipe flow model. The description of the flow model is based on a nonlinear differential equation. The chosen model approach contains modeling of an external exhaust-gas recycling system, variable inlet systems and systems with variable control valves. The model-assisted load detection method can be used in engine control systems based on air mass flow and on inlet pipe pressure. A correction algorithm, in the form of a model control loop allows permanent improvement of accuracy when the model parameters are inexact. That is to say model balancing is provided in steady and unsteady operational states.

Process for model-assisted determination of the fresh-air mass flowing

A method for determining an air mass flow into cylinders of an internal combustion engine with the aid of a model includes calculating an air mass actually flowing into a cylinder with the aid of an intake tube filling model supplying a load variable on the basis of which an injection time is determined, from input variables relating to throttle opening angle and ambient pressure and from parameters representing valve control. The load variable is used for prediction in order to estimate the load variable at an instant which is at least one sampling step later than a current calculation of the injection time.

Method for determining an air mass flow into cylinders of an internal

A method of determining a mass of fuel to be introduced into a suction pipe or into a cylinder of an internal combustion engine precontrols a basic injection time constituting a basic injection quantity, through a prescription of a lambda set point. The lambda set point is determined by a coordinated calculation through selecting a minimum and a maximum from a multiplicity of different lambda requirements which are derived from operating states of the internal combustion engine. Different priorities are allocated to the various lambda requirements.

Method of determining the mass of fuel to be introduced into the suction

A method for detecting bad stretches of road includes ascertaining a tripping variable representing acceleration of at least one wheel of a vehicle. A bad stretch of road is detected if the amount of the tripping variable exceeds a predeterminable limit value. The tripping variable is dependent on at least two segment times that the wheel needs to pass through associated angle segments.

Method for detecting stretches of bad road

A method for recognizing stretches of rough or bad road includes recognizing tank pressure values at successive evaluation instants. A change in tank pressure is ascertained from successive tank pressure values. A stretch of rough or bad road is recognized if the change exceeds a limit value.

Growing community of inventors

Wuppertal, Germany

Maximilian Engl