Super Micro Computer, Inc.

Mau-Lin Chou

Manhtien V Phan

Chih-Hao Lee

John Chen

A circuit board has an edge connector with signal traces. The signal traces are formed on a dielectric layer of the circuit board. A reference trace is formed within the dielectric layer or on another surface of the dielectric layer. Parameters of the reference trace are adjusted to set an impedance of a single-ended signal trace or a differential impedance of two adjacent signal traces.

Setting the impedance of signal traces of a circuit board using a reference trace

A circuit board has an electrical circuit and a connector that is attached to the circuit board. The connector has metal contacts. A housing of the connector has an embedded reference metal layer that is disposed under a single-ended metal contact or differential metal contacts. The reference metal layer sets the impedance of the single-ended metal contact or the differential metal contacts.

Reference metal layer for setting the impedance of metal contacts of a connector

A cable assembly has a cable with a transceiver module on one end. The transceiver module is plugged into an interface connector of a circuit card, which also has a network interface controller chip, an onboard non-volatile memory, and a control unit. The control unit reads cable assembly data stored in a non-volatile memory of the transceiver module over a serial bus and copies the cable assembly data to the onboard non-volatile memory. The control unit initiates transfer of the cable assembly data from the onboard non-volatile memory to a communication port of the network interface controller chip over another serial bus.

Growing community of inventors

Milpitas, CA, United States of America

Mau-Lin Chou