Hitachi, Ltd.

Hitachi Cable, Inc.

Shin-Kobe Electric Machinery Co., Ltd.

Hitachi Chemical Company, Ltd.

Masahiro Watanabe

Yasuo Sato

Yasushi Tomita

Keiko Abe

Masahiko Amano

Kazuo Kato

Hiroo Konishi

Yoshikazu Hirose

Takafumi Ebara

Hisaaki Takabayashi

Yuichi Otake

Yasuhiro Kobayashi

Tatsuya Yamada

Yasushi Harada

Noriyuki Murakoshi

Shouji Matsuzaki

Shinichirou Nakanami

Kenji Ogawa

Rena Tachihara

Tomoharu Nakamura

Akira Kobayashi

Shinya Tanifuji

Katsuya Akimoto

Masayuki Tani

Takaharu Ishida

Kazuyuki Iizuka

Shinichi Sano

Eisuke Kuroda

Minoru Kanoi

Taminori Tomita

Toshiyuki Sawa

Toshifumi Yoshikawa

Yasutaka Kimura

Tsukasa Onishi

Taichiro Kawahara

Ichiro Shimoura

Toshiyuki Furukawa

Saburo Yasukawa

Hideyuki Kawamura

Yuzuru Imamura

Tetsuji Fujimoto

Ikurou Masuda

Isao Ueno

Shinji Tanifuji

Masashi Nishimura

Kazuyuki Ilzuka

Takao Matsuzaki

An accumulator and state of charge evaluation method for preparing, during charging and discharging, models for each of deterioration degrees, each representing a relationship between terminal voltage, current and state of charge, for selecting respective models for the times during charging and discharging in accordance with a total charging/discharging amount (Ah), a deterioration degree or an elapsed time of an operation of the accumulator, for further estimating state of charge from current accumulation, and for determining a final state of charge from estimated states of charge including a present state of charge estimated from the models for the times during charging and discharging of the accumulator, while using a time or a total charging/discharging amount (Ah) from a time of full-charging by equal charging of the accumulator up to present time to determine the final state of charge from the plurality of states of charge.

Accumulator device, and state of charge evaluation apparatus and method for accumulator

If a failure has occurred on the backbone-power-transmission-network side, i.e., the electric-power system, and if the power supply to a power-distributing/transforming substation is stopped, a power-distributing feeder is cut off from the electric-power system. Moreover, a monitor/control apparatus transmits a single-operation-permitting permission signal to a distributed power-source system which is connected to the cut-off power-distributing feeder. Here, the distributed power-source system supplies its power to the power-distributing feeder only during a time-interval in which the system is receiving the permission signal. A general load and an important load, which are connected to the power-distributing feeder, find it possible to continue their activities by taking advantage of this power.

Power monitor and control apparatus and control apparatus of distributed powering system

A command system of a power conditioning system of the present invention receives return pattern information including a time instance and an upper output limit, and issues a command with respect to the upper output limit of the power conditioning system, the return pattern information being for preventing the frequency of an isolated power system, which is calculated by a planning server, from causing a sharp change.

Power conversion device, control device for power conversion device, and control method for power conversion device

The battery charging of electric vehicles, etc. is controlled so that the impact on the electric power system is lightened even when a lot of electric vehicles, etc. start the charging all at once. A device for controlling an electricity storage device installed in an electric vehicle or the like calculates a voltage drop by applying a load current at the time of performing the charging of the electricity storage device, and limits the charging quantity of the storage battery (installed in the electric vehicle or the like) based on the calculated voltage drop so that the voltage drop of the electric power system remains less than a prescribed level. Consequently, it becomes possible to reduce the voltage fluctuation around each of the electric vehicles, etc. that is about to execute the charging in cases where a lot of electric vehicles, etc. start the charging all at once.

Storage battery control device, charging station, and storage battery control method

While a control method is established which can maximize the lifetime of an storage battery based on a SOC capable of maximizing the lifetime of the storage battery under a temperature condition and a wind condition at an electricity generation site and on currently known ones of other operational conditions, a control system is constructed which can feedback to an actual wind power generation and storage battery system. The control system includes a wind power generation and storage battery system, an storage battery operation and deterioration data collection unit for collecting data of the wind power generation and storage battery system, an storage battery operation and deterioration relation assessment unit for assessing a relation between an operation of the storage battery and deterioration thereof based on the collected data, an storage battery operation planning unit for planning such a method of operating the storage battery as to satisfy a necessary lifetime requirement using information obtained by the storage battery operation and deterioration relation assessment unit, and an storage battery operation instruction unit for instructing the wind power generation and storage battery system to operate the storage battery in accordance with the plan of the storage battery operation planning unit.

System for control of wind power generation storage battery and method of control thereof

A distributed energy resources control apparatus for controlling power from a distributed energy resource in a system section separable from a power system includes a detecting unit, a receiving unit, and a control unit. The detecting unit detects a fault of the power system. The receiving unit receives a signal indicating authorization for the distributed energy resource to perform independent operation as linking with the system section, when the system section is separated from the power system. The control unit controls a power converter converting power from the distributed energy resource and outputting to the system section, based on measurement results of a voltage and a frequency of the system section, when the fault is detected and the signal is received.

Distributed energy resources control apparatus and distributed energy resources control method

The life of a lead acid storage battery is extended by changing an over-frequency equalized charge interval performed on a lead acid storage battery, in accordance with a transition situation of a state of charge (SOC) of the lead acid storage battery. The lead acid storage battery is also made to be advantageous in terms of cost by reducing the equalized charge with a low degree of urgency to reduce the power and cost for equalized charge, and by reducing the number of stops of a natural energy storage system. A lead acid storage battery and a lead acid storage battery system whose operational management can be easily performed are achieved by a method in which the future timing when the equalized charge is performed can be grasped by people operating the lead acid storage battery.

Lead acid storage battery and lead acid storage battery system for natural energy utilization system

A battery control apparatus of this invention is provided which comprises: a battery installed on a feeder of a utility distribution system; batteries installed between pole-mounted transformers and branch points of the distribution lines; a communication network to transmit measurement data measured by meters; a battery control quantity calculation unit to determine battery control quantities from the measurement data acquired from the communication network; a load data collection unit to collect load data representing a combination of power consumption by a plurality of loads and generated power of distributed power generations; a frequency conversion unit to perform a frequency analysis on the load data; an intermediate-cycle component extraction unit to extract intermediate-cycle components; a battery control quantity calculation unit to determine battery control quantities from the extracted intermediate-cycle components; and a battery control command transmission unit to transmit the calculated control quantities to the batteries.

Method and apparatus for control battery and specification determining method of battery

A power demand/supply management server () obtains information defining restraint contents to a comfort and an electricity bill from a consumer power operating device (). An individual-consumer control optimizing unit of the power demand/supply management server () calculates control contents to an electrical equipment having a minimum cost evaluation value based on a simulation result of cost evaluation values which are barometers for evaluating a comfort and an electricity bill excessiveness, and transmits the calculated control contents to the consumer power operating device (). Also, a whole-consumer optimizing unit of the power demand/supply management server () calculates the most appropriate electricity unit meter-charge that ensures a necessary demand suppression plan level throughout the whole power system based on an electricity daily load curve for each consumer.

Power demand-supply management server and power demand-supply management system

An energy management system includes an equipment data management unit which manages charging/discharging loss of a battery and heat radiation loss of an electric water heater, and causes a control unit to perform control to give priority based on the comparison to the energy storage facility more reducing loss and store energy. The energy management system includes a system operation calculation unit which predicts voltage distribution of the next day of a distribution system or demand-and-supply balance amount of the entire system by state monitoring data of a power system, calculates a demand amount increasing target value necessary for avoiding a photovoltaic power generation amount suppression on a consumer end by the voltage distribution of the next day of the distribution system or the demand-and-supply balance amount, and controls the energy storage facilities so as to satisfy the demand amount increasing target value on the consumer end.

Energy management system, energy management apparatus, and energy management method

A customer-dedicated energy management apparatus includes an air-conditioner partial-road characteristics identification unit for creating air-conditioning partial-road characteristics by using air-conditioning operation achievement data in the past, an intra-room heat-capacity characteristics identification unit for creating intra-room heat-capacity characteristics by using the air-conditioning operation achievement data in the past, and intra-room state value data, an air-conditioning setting temperature calculation unit for determining an air-conditioning setting temperature by using the air-conditioning partial-road characteristics and the intra-room heat-capacity characteristics, the setting temperature being appropriate for implementing an air-conditioning power-consumption-amount suppression target value determined, and an air-conditioner control unit for controlling an air conditioner so that the setting temperature determined will be implemented.

Energy management apparatus for customers

A light emitting device has a light emitting layer having a first semiconductor layer of a first conductivity type, a second semiconductor layer of a second conductivity type different from the first conductivity type, and an active layer sandwiched between the first semiconductor layer and the second semiconductor layer, a reflecting layer provided on a side of one surface of the light emitting layer, which reflects a light emitted from the active layer, a supporting substrate provided on an opposite side of the reflecting layer with respect to the light emitting layer, which supports the light emitting layer via an adhesion layer, an ohmic contact portion provided on a part of the reflecting layer, which electrically connects between the reflecting layer and the light emitting layer, and convexo-concave portions formed on other surface of the light emitting layer and side surfaces of the light emitting layer, respectively, and an insulating film configured to cover the convexo-concave portions.

Light emitting device

A solar power generation system comprising: plural customers each having a solar panel, a power convertor for converting DC output from the solar panel into AC output, an output controller for suppressing the power convertor output which becomes higher than a predetermined value, a measuring unit for measuring the amount of sold power, the amount of purchased power and the amount of generation-suppressed power; and an watt-hour meter measurement data adjusting unit linked with the plural customers via communication lines. The watt-hour meter measurement data adjusting unit calculates provisional generation-suppressed power amounts that make the burdens of the customers even, and calculates the power amounts to be sold by the customers on the basis of the provisional generation-suppressed power amounts. Thus, the generation-suppressed power of the solar power generation system can stabilize the power system and the chances for selling power can be fairly allocated to customers having solar panels.

Renewable electricity generation system, electric power measurement device and method

A charge/discharge control apparatus includes: a charge/discharge reward information receiving unit for receiving charge/discharge reward information representing a reward given to a charge/discharge action of a customer and a restriction in conducting a charging/discharging from a charge management central server; a computing unit for creating a charge/discharge plan including a total charging quantity in a time zone and an estimated use start time of an electric vehicle such that a reward is maximized, based on the charge/discharge reward information; a charge/discharge instruction transmitting unit for instructing the electric vehicle to start or finish a charging/discharging according to the charge/discharge plan; a charge/discharge quantity monitoring unit for monitoring the charging/discharging; and a charge/discharge results transmitting unit for transmitting results of monitored charging/discharging including contents of the conducted charging/discharging and individual identification information for identifying itself, to a charge management central server.

Charge/discharge control apparatus

A semiconductor light emitting element includes a group III-V compound semiconductor layer, a first main surface and a second main surface, a reflection metal film formed on the second main surface, a front surface electrode formed on the first main surface, and an ohmic contact joint part formed between the reflection metal film and the group III-V compound semiconductor layer except a region directly under the front surface electrode. The ohmic contact joint part is disposed in a side of an outer peripheral part of the semiconductor light emitting element, formed so as to surround the front surface electrode when the ohmic contact joint part is viewed from a side of the front surface electrode, and disposed so that distance from each location of outer edge parts of the front surface electrode to the ohmic contact joint part nearest to the each location becomes equal to each other.

Semiconductor light emitting element

Growing community of inventors

Hitachi, Japan

Masahiro Watanabe