Gm Global Technolgoy Operations, Inc.

Martin Gentile

Gernot Becker

Julian Heinz

Brandon M Fell

Henry R Wright

Matthias Urban

Marcel Wachtel

Armin Mueller

Markus Steckhan

Thomas Stock

Rainer Kloesel

Falko Hendrischke

A motor vehicle drivetrain features an input shaft, an output shaft, a continuously variable transmission for coupling the input shaft to the output shaft with a variable transmission ratio between the input shaft and the output shaft, and a bypass transmission with at least one bypass gearing, which has a fixed transmission ratio, in order to couple the input shaft to the output shaft. A value of a transmission ratio of the bypass gearing is less than or equal to half the sum of a value of the maximum forward motion and a value of the minimum forward motion of the variable transmission ratio between the input shaft and the output shaft driven of the continuously variable transmission and/or less than or equal to 1.0. The bypass transmission is configured for driving the motor vehicle with a driving speed of at least 50 km/h or 31 mph.

Motor vehicle drivetrain

A method of adjusting deceleration dependent shift points to maintain a target minimum turbine speed includes calculating a vehicle speed offset based on vehicle acceleration rate a predicted downshift delay for the target minimum turbine speed and converting the target minimum turbine speed to a target vehicle speed based on the deceleration condition. Thereafter, the method continues with determining a target gear based on the vehicle speed offset and the target vehicle speed, and downshifting to the target gear having vehicle speed less than or equal to a vehicle speed corresponding to the current turbine speed. The method ends with maintaining the target gear until a shift delay period is greater than a predetermined delay threshold.

Method of adjusting deceleration dependent shift points

A method for controlling a powertrain includes the following steps: (a) determining whether a vehicle is coasting to a stop based on an accelerator pedal position; (b) determining whether an automatic transmission is in first gear; (c) shifting an input clutch from an engaged state to a disengaged state in order to operatively disconnect the automatic transmission from an internal combustion engine if the vehicle is coasting to a stop and the automatic transmission is not in first gear; and (d) shifting the automatic transmission to the first gear in order to allow the internal combustion engine to be shut down while the vehicle is coasting to a stop.

Method for controlling a powertrain and a transmission system

A motor vehicle is provided having a combustion engine, an automatic transmission, a turbocharger with variable geometry pre-compressing combustion air for the combustion engine and a turbocharger control unit for varying the turbocharger geometry, the turbocharger control unit is equipped before a downshifting of the automatic transmission to vary the geometry in the turbocharger in the direction of a reduction of the rotational speed of the turbocharger.

Motor vehicle with turbocharger

A control system is provided for shifting an automatic transmission of a motor vehicle, which includes, but is not limited to a speed controller, and an electronic control device. Through the electronic control device the parameters vehicle speed, position of the speed controller and acceleration of the speed controller can be captured. Through the electronic control device and through comparison of the captured values of the parameters with predetermined reference values a shifting time is determined for shifting the automatic transmission.

Growing community of inventors

Ruesselsheim, Germany

Martin Gentile