Rockwell Automation Technologies Incorporated

Mark S Williams

Nathan Joseph Molnar

Michael S Baran

John C Laur

Michael A Sutton

Gary Dan Dotson

Douglas Alan Lostoski

Douglas Robert Bodmann

Garron Koch Morris

Shawn D Cloran

Andrew P Kaufman

John M Van Hecke

Christopher Genthe

Shravan Rajmohan

Pete J Klein

William M Ruddy

Kenneth J Lutze

Geoff M Sieron

Daniel L Stefaniak

Senthil P Kumar

Paul Leone

A touchscreen for a display device may include a top layer, a bottom layer, and a middle layer between the top layer and the bottom layer. The touchscreen may also include a deposited material that extends around a perimeter of the touchscreen. A length of the deposited material has a length that extends from at least a first portion of the top layer to at least a second portion of the bottom layer. The deposited material may form a seal over the middle layer between the touchscreen and an environment of the display device.

Industrial automation display device with touchscreen

An electronics module includes a housing with: (i) a forced convection chamber including an internal forced convection space; and, (ii) a passive chamber including an internal passive space that is separated from the forced convection space. At least one fan is connected to the housing and adapted to induce forced convection airflow in the forced convection space. A heat sink is connected to the housing and includes: (i) a heat input portion exposed to the passive space; and, (ii) a heat output portion exposed to the forced convection space. A circuit board assembly is located in the passive space and includes at least one electronic component that is thermally engaged with the heat input portion of the heat sink. A clamping plate is secured to the heat sink and captures the circuit board to the heat sink. The circuit board is isolated from the fan-induced forced convection airflow.

Controller with heat sink clamping plate for enhanced thermal properties

A user interface display device for displaying information associated with an industrial automation system may have a display that has a front face and one or more outer edges, a cover lens optically bonded to the front face of the display with an optical-grade adhesive, and a bezel that has a frame. The frame is disposed about the display, and the bezel defines a gap between the frame and the one or more outer edges of the display. The display device may also have a quantity of gap-filling adhesive disposed at one or more locations within the gap between the one or more outer edges of the display and the frame of the bezel. The quantity of gap-filling adhesive may couple the display to the bezel.

Industrial automation display device

Controller with enhanced thermal properties

The disclosed subject matter comprises a display retention bracket (DRB) that can be attached to, and can retain and horizontally mount, a display using display retention components, without using fasteners, for insertion of the display in a bezel that does not support horizontal mounting; and includes: a cable retention component that enables the cable to withstand a specified pull-out force to maintain connection of the cable to the display; a cable guide to maintain cable wires in a desired position in relation to other components; alignment pins to align the DRB and display with a bezel housing; non-symmetrical tabs to ensure the display is oriented correctly; offset columns that desirably offset loads on the display when an adapter plate is applied onto the DRB and display, and fastened to the bezel to secure the display; and a ground clip to extend the ground path from the bezel to the display.

Display mounting techniques

A mounting assembly for fastening a device housing onto a panel includes a housing and a clamp. The panel defines a front surface, a rear surface, and an opening extending therethrough for receiving the housing. The housing includes at least one wall sized to extend through the opening. The wall defines a bearing surface. The clamp includes a beam member and a head member. The beam member extends from the wall at a first end. The beam member is biased to deflect outwardly with respect to the wall at an oblique angle. The head member extends from a second end of the beam member and includes a first cam surface for engaging the rear surface of the panel and a second cam surface for engaging the bearing surface of the housing.

Panel mounting system

Cup holder

Growing community of inventors

Waukesha, WI, United States of America

Mark S Williams