Magneti Marelli Powertrain, S.p.a.

Mario Marconi

Stefano Musolesi

Roberto Piciotti

Claudio Fauni

Riccardo Nazzaro

Gabriele Giuliani

Marcello Sciuto

Giorgio Ferretti

Alessandro Peciarolo

A method of manufacturing and controlling a butterfly valve for an internal combustion engine; the manufacturing and control method includes the steps of: establishing a maximum gaseous flow rate value which may flow through the feeding pipe when the butterfly plate is in the closing position; determining a conventional closing position at which the gaseous flow rate which flows through the feeding pipe is essentially equal to the maximum gaseous flow rate value; driving an actuator device so as not to normally pass the conventional closing position; and dimensioning the position of a catch element, so that when a rotational shaft abuts against the catch element the gaseous flow rate which flows through the feeding pipe is essentially lower than the maximum gaseous flow rate value.

Method of manufacturing and controlling a butterfly valve for an internal combustion engine

A throttle valve for an internal combustion engine, the throttle valve having: a valve seat; a throttle disk, which engages the valve seat and is rotated by an electric motor between an open position and a closed position; a gear transmission connecting the electric motor to a shaft of the throttle disk; a position sensor for determining the position of the throttle disk; a housing chamber housing the electric motor, the gear transmission, and the position sensor; and a rigid plate, which is housed inside the housing chamber, and supports a stator of the position sensor, electric terminals of an electric connector, and a connecting printed circuit which connects the stator of the position sensor and the electric motor electrically to the electric terminals of the electric connector.

Internal combustion engine throttle valve

Growing community of inventors

Bologna, Italy

Mario Marconi