Magneti Marelli Powertrain, S.p.a.

Marcello Sciuto

Piero Maria Carbonaro

Gabriele Giuliani

Mario Marconi

Alessandro Peciarolo

Sergio Vigna

Francesco Del Mese

A method of manufacturing and controlling a butterfly valve for an internal combustion engine; the manufacturing and control method includes the steps of: establishing a maximum gaseous flow rate value which may flow through the feeding pipe when the butterfly plate is in the closing position; determining a conventional closing position at which the gaseous flow rate which flows through the feeding pipe is essentially equal to the maximum gaseous flow rate value; driving an actuator device so as not to normally pass the conventional closing position; and dimensioning the position of a catch element, so that when a rotational shaft abuts against the catch element the gaseous flow rate which flows through the feeding pipe is essentially lower than the maximum gaseous flow rate value.

Method of manufacturing and controlling a butterfly valve for an internal combustion engine

A method for controlling an electric motor by using the PWM technique including the steps of: applying to the clamps of the electric motor an electric voltage varying in time, which displays a square waveform and consists of a sequence of pulses having a uniform wave period and a variable width; adjusting the average value of the electric voltage by varying the width of the pulses; determining the overall required width variation; subdividing the overall required width variation in a determined number of partial variations, the overall sum of which is equivalent to the overall required width variation; and gradually varying the width amplitude of the pulses of the electric voltage by applying in a sequence a corresponding partial variation to each pulse, so that the difference between the width amplitude of a pulse and the width of a following pulse is equivalent to the corresponding partial variation.

Method for controlling an electric motor by using the PWM technique

Growing community of inventors

San Giovanni in Persiceto, Italy

Marcello Sciuto