L3harris Technologies, Inc.

L3 Technologies, Inc.

Marc Padilla

David M Arnesen

Nicholas T Yaskoff

Samuel Charles Kingston

Osama Sami Haddadin

Radivoje Zarubica

Brent A Kenney

Matthew J Reimann

Philip M Hirz

Brian J Thorp

Patrick L Newbold

Matthew A Lake

Michael S Feeney

Christopher S Heffernan

Bryan J Thorp

A radio frequency (RF) communications system may include a first RF node that transmits data, including a new frequency of operation, and a sequence of pilot symbols spread with a complex spreading code sequence. A second RF node may receive an incoming signal from the first RF node and perform despreading for N sample offset delays to generate N despreading sequences for the sequence of pilot symbols. The second RF node may perform a cross-correlation to select a desired despreading sequence from the N despreading sequences, determine a phase offset and timing offset, process the incoming signal based upon the desired despreading sequence, phase offset and timing offset, and switch to the new frequency of operation.

Radio frequency (RF) communications system having RF nodes that determine a despreading sequence and phase and timing offsets for frequency agility

Indicating to a receiver node in a network that the receiver node should begin tracking signal to noise ratio (SNR) of a received signal for a new power and rate (PAR) interval for data sent from a transmitter node. A method includes determining that a new PAR interval is beginning. The method further includes adding an identifier to a data block. The identifier corresponds to the new PAR interval. The method further includes sending the data block from the transmitter node to the receiver node, where the receiver node will use the identifier to determine that a new tracking interval of SNR should be performed for the data block and subsequent data blocks having the identifier.

Deterministic power and rate control

Embodiments are directed to synchronizing time among nodes in a network. In one scenario, a first node receives a timing message which provides an indication of the current time as measured by a second node at transmission of the timing message. The first node determines the timing message propagation time between the first and second nodes using a determined transmission frequency of the timing messages, an internal clock reading of a clock that indicates the current time in the first node, and timing and frequency measurements obtained at the first and second nodes. The first node also applies a weighting factor to the current time of the first node to adjust the current time forward or backward, and combines the determined propagation time with the adjusted clock time of the first node to generate a new, synchronized time and transmission frequency, which is broadcasted to other nodes in the network.

Distributed network time synchronization using geo-beacons

Growing community of inventors

Farmington, UT, United States of America

Marc Padilla