Ultra Communications, Inc.

Man W Wong

Joseph Farzin Ahadian

Charles B Kuznia

Richard J Pommer

Richard T Hagan

Howard Arthur Lenos

Sandra Skendzic

Methods and devices for a single wavelength fiber optic sensor system are described. Sensing is based on relative shift in spectral responses of two co-located fiber gratings (FBGs) within a fiber optic cable and measured at one measurement wavelength. Under a range of conditions of interest, the shift in spectral responses maintains the measurement wavelength within respective slopes of the spectral responses. A normalized difference in reflected power is used to desensitize the measurement from any variation in power of the single laser power and/or in loss through the fiber optic cable. Several pairs of co-located FBGs may be used within the same fiber optic cable, each pair used for sensing at a corresponding location. An OTDR system couples light pulses at the measurement wavelength to the fiber optic cable, and measures amplitudes and timing of corresponding reflected light pulses to perform the normalized difference.

Single wavelength fiber grating sensing with spatial location

A protective assembly method using a transparent layer within the fiber interconnect system aids in optical coupling by preventing an air gap from forming between the fiber cores within a connector. A fiber protection device made of a thin transparent film, which includes an adhesive layer, is applied over the fiber end-faces at the connector interface, the film having characteristics which allows it to conform to the fiber end and minimize coupling loss between fibers. According to one aspect, the film is part of a cartridge that provides structural support for the film to facilitate application of the fiber protection device. The film may be divided by perforate patterns that define one or more fiber protection devices formed by the film. The assembly method can include usage of an applicator base plate upon which the cartridge is mounted. According to another aspect, the film may be part of a single-use disposable pod for application of a single fiber protection device.

Single-use disposable pod for application of an optical fiber protection device

A protective assembly method using a transparent layer within the fiber interconnect system aids in optical coupling by preventing an air gap from forming between the fiber cores within a connector. A thin transparent film (or with adhesive) is placed over the fiber end-faces at the connector interface, the film having characteristics which allows it to conform to the fiber end and minimize coupling loss between fibers. The film is sized to fit connectors faces and can be temporary, being replaced with each installation. A coating can also applied to the connector surface, providing a similar effect, as well as structurally enhancing the connector surfaces.

Fiber optic end-face transparent protector system and method

Fiber optic end-face transparent protector

Growing community of inventors

San Diego, CA, United States of America

Man W Wong