Yanmar Co., Ltd.

Makiko Tajima

Kunihiko Sakamoto

Hiroaki Ayabe

Seiji Sakada

Yousuke Yamashita

Kouichi Takata

Nagahiro Ogata

Masaaki Yamashita

Rigidity of a frame of a working vehicle is improved by a simple structure and production costs are reduced by reducing the number of parts of a working vehicle. Pipesare provided on both left and right sides at the center in the front-rear direction of a side frame, and each pipehas a rectangular cross-section and penetrates an intermediate partition in the front-rear direction from a mast sectionup to a transmission section. Tie-down holes are formed in a front face plateto which the front end of a frameis connected, and a plateconnected to a side frameis provided at the bottom surface of each mast sectionprotruding outward from the side frame. Tanks installed on the working vehicle are suspended from the plate bodies, and a lift arm installation boss provided at each mast sectionis supported at both ends. A U-shaped reinforcement memberconnects the upper surface of mast partition plate of a mast sectionand left and right bosses.

Frame structure for working vehicle

A lift arm having a plate-like structure that is capable of taking a large load is realized without increasing a plate thickness and at low cost. The structure with required strength and of low cost is realized by a simple construction and achieves, at the same time, both weight lightening of a loader and sufficient load bearing performance. In a loader () of a working machine (), connection sections between a cross member () and lift arms () are each formed in a shape broadening from the cross member () toward a lift arm (). Further, reinforcement plates are attached to outer surfaces of a front loader () so as to overlap the connection sections between the cross member () and the lift arms (). Contact members () are attached to lower side faces at the heads of the lift arms () to restrict the amount of rotation of a working device installed on the heads of the lift arms ().

Loading device for working machine

Production of a working vehicle frame consumes high costs because it requires high rigidity. A simple construction improves the rigidity of the frame and reduces costs required for the production. In a structure of a frame () for a working vehicle (), side sections of the frame () are constructed in a boat form, and, in a front view, the width of a lower section of the frame () is set smaller than that of the central section in the vertical direction of the frame (). Further, a mast plate () for supporting a front loader () and a front axle installation plate section () are integrated, and side frames () constructing the side section of the frame () and the mast plate () are jointed in a lateral T shape in a side view.

Tractor

Growing community of inventors

Chikugo, Japan

Makiko Tajima