Nkf Kabel B.v.

Draka Comteq B.v.

Maja Keijzer

Willem Griffioen

Willem Greven

Cornelis Van 't Hul

Patrick Menno Versteeg

Cornelis Van't Hul

Cornelus Van T'Hul

A cable is installed in a duct by means of blowing (and, optionally, synergetic pushing) and lubricating the cable during field installation. Lubricating the cable is done after the cable exits from the cable blowing equipment and hence takes place in a pressurized airflow passage. Lubricant supplied from an external reservoir drains into a pressurized lubricator space through which the cable moves. Foam-plugs seal the entrance and the exit of the lubricator space. The cable is wetted by the lubricant as it moves through the lubricator space, and excess lubricant is wiped by the foam plug, leaving only a thin film of lubricant on the cable as it moves out of the lubricator. In one embodiment, the lubricator is fitted with a single wiping member in the form of an annular plug of open cell foam material, and the cable passes through laterally opposite sections of the annular plug. The lubricator housing is formed in mating sections, and the internal lubricator is also formed in mating sections. The lubricator is integrated with cable blowing equipment in one embodiment. A bundle of guide tubes is lubricated in another embodiment.

Optical cable lubricator with reservoir

A cable is installed in a protective duct or guide tube by means of blowing (and, optionally, synergetic pushing) and lubricating the cable during installation. Lubricating the cable is done after the cable exits from the cable blowing equipment and hence takes place in a pressurized airflow passage. A hollow chamber filled with foam-plugs saturated with lubricant forms the cable lubricator. Lubricant is wiped onto the cable as it moves through the pressurized lubrication compartment. A portion of the airflow used for propelling the cable during blowing installation is bypassed around the lubricator and injected into the duct trajectory downstream of the lubricator.

Optical cable installation with cable lubricator

A cable is installed in a guide tube by means of blowing (and, optionally, synergetic pushing) and lubricating the cable during this installation. Lubricating the cable is done after the cable has passed the cable blowing equipment and hence takes place in a pressurized airflow passage. A hollow chamber filled with foam-plugs saturated with lubricant forms the cable lubricator. To avoid buckling, cable guide blocks are placed, which also divide the lubricator in different sub-chambers, each with its own foam-plug and content of lubricant. The airflow, needed to propel the cable during blowing, can bypass the lubricator.

Growing community of inventors

Delft, Netherlands

Maja Keijzer