Luk Lamellen Und Kupplungsbau Gmbh

Louis F Schulte

Wolfgang Reik

Paul Maucher

Burkhard Brandner

Boguslaw Maciejewski

Jorg Holwe

The hub of a composite flywheel is made of cast steel and comprises an axial extension with an external surface which is a press fit in a disc-shaped element of the primary flywheel of the composite flywheel. A centrally located through hole of the hub is surrounded by a second surface constituting a seat for and being a press fit on the outer race of a pilot bearing for the input element of a variable-speed transmission receiving torque from the composite flywheel through a friction clutch. The extension is made yieldable so that its fitting into the disc-shaped element does not result in deformation of the second surface and does not cause problems in connection with installation of the pilot bearing in the hub. Moreover, the clearance between the pilot bearing and the hub cannot be reduced below a value which could entail premature wear upon the bearing and would shorten the useful life of the composite flywheel.

Carrier for use in torque transmitting apparatus

The operation of an automated friction clutch between the output element of the engine and the input element of the variable-speed transmission in a motor vehicle is regulated by a fluid-operated system which receives signals from an evaluating circuit. The evaluating circuit receives signals from a number of sensors which monitor the RPM of the engine, the RPM of the input element of the transmission, clutch travel, the position of the throttle valve, the position of the shift linkage, the position of the gas pedal and other parameters. The fluid-operated system can select the condition of the clutch during starting, driving, acceleration, parking, driving in reverse and/or parking of the motor vehicle and/or during transitions between such stages of operation.

Growing community of inventors

Ottersweier, Germany

Louis F Schulte