Gm Global Technolgoy Operations, Inc.

Loren Devries

Bruce Jeffrey Clingerman

Abdullah Basar Alp

Derek R Lebzelter

Aaron R Rogahn

John P Salvador

Steven R Falta

Sriram Ganapathy

Seth E Lerner

Yanyan Zhang

Joseph Mussro

Todd Kenneth Preston

Joseph D Rainville

Jun Cai

John P Nolan

Joseph C Gerzseny

William S Marley

A system and method for operating a fuel cell stack of a fuel cell system in a vehicle when an error in cathode air flow rate is detected. The system and method include estimating a cathode air flow rate and detecting an error in the estimated cathode air flow rate. The system and method also include utilizing high frequency resistance measurements from a high frequency resistance sensor to control a relative humidity of the fuel cell stack when the error in the estimated cathode air flow rate has been detected.

Remedial actions for air flow errors in a fuel cell system

A system and method for determining the maximum allowed stack current limit rate for a fuel cell stack that considers cell voltage. The method includes estimating a fuel cell stack voltage based on a fuel cell resistance value, stack variables and a current request signal. The fuel cell resistance value can be modeled based on stack temperature and stack relative humidity. The stack variables can include exchange current density and mass transfer coefficient. The method then uses the estimated fuel cell voltage and a look-up table based on estimated voltage to determine a current rate limit value for changing the current of the stack. The method then adds the current rate limit value and the current request signal to obtain the current set-point.

Method to improve fuel cell system performance using cell voltage prediction of fuel cell stack

A system and method for determining a loss of cooling fluid from a thermal sub-system in a fuel cell system. The method includes monitoring current feedback from a high temperature pump that pumps the cooling fluid through a coolant loop. A measured current from the pump is compared to an expected current for the system operating conditions, and if that current is significantly less than what is expected, then it may be as a result of low cooling fluid. If the measured current is less than the expected current for a predetermined period of time, then the system can take mitigating action as a result of a low cooling fluid. Further, if the pump speed is too low to provide an accurate current measurement, then it can be increased if an overflow tank level sensor indicates a low cooling fluid level.

Method to detect gross loss in coolant based on current feedback from the high temperature pump

A method for determining whether a fuel cell stack cooling fluid is flowing at cold fuel cell system start-up. The method monitors the temperature of the cooling fluid outside of the fuel cell stack, and determines whether the temperature of the cooling fluid is increasing properly as the temperature of the stack increases.

Method to detect no coolant flow in a fuel cell system

A method for improving fuel cell system reliability in the event of end cell heater failure in a fuel cell stack. The method includes detecting that an end cell heater has failed. If an end cell heater failure is detected, then the method performs one or more of setting a cooling fluid pump to a predetermined speed that drives a cooling fluid through cooling fluid flow channels in the fuel cell stack, limiting the output power of the fuel cell stack or the net power of the fuel cell system, limiting the maximum temperature of the cooling fluid flowing out of the stack, turning off stack anti-flooding algorithms that may be used to remove water from reactant gas flow channels in the stack, and turning off cathode stoichiometry adjustments for relative humidity control in response to water accumulating in cathode flow channels in the fuel cell stack.

Method for improving FCS reliability after end cell heater failure

A method for performing a plausibility check of a fuel cell stack anode side pressure sensor to determine whether the pressure sensor is providing an accurate measurement. Prior to system start-up when a cathode side compressor is not providing cathode air to a fuel cell stack, and the cathode side of the stack is at ambient pressure, a pressure measurement from a differential pressure sensor between the anode side and the cathode side of the fuel cell stack is provided. The differential pressure sensor reading is added to a pressure measurement from an ambient pressure sensor, where the sum should be about the same as the pressure measurement from the anode side pressure sensor if the anode side pressure sensor is operating properly.

Method and algorithm to detect frozen anode pressure sensor

Growing community of inventors

Rochester, NY, United States of America

Loren Devries