International Business Machines Corporation

Kristen A Hausman

Joseph M Mosley

Gene J Gaudenzi

Susan L Tempest

Each section (e.g., 102) of the ring oscillator consists of three two-input NOR gates; one in the feedforward path (108), one in the feedback path (112), and one in the crossover path (110). The center frequency of the oscillator is controlled by enabling and disabling the appropriate gates, such that a single closed loop path is formed. The gates in the feedforward and crossover paths are directly enabled or disabled (to disable, either input is held high) from a control circuit (FIG. 2). The gates in the feedback path, however, are indirectly enabled and disabled. To enable a particular feedback path gate (e.g., 118), either the corresponding crossover gate (116) is disabled, or the corresponding feedforward gate is disabled (114) and the crossover gate (122) in the following section is enabled. The later causes the feedback gate (124) in the following section to be disabled, thereby removing the remaining sections (106) of the oscillator from the closed loop path. The NOR gates are implemented as a differential amplifier (FIG. 5) having two transistors (610 and 612) in the input leg and one transistor (616) with its base connected to a regulated voltage (Vr) in the opposite leg. The output of the NOR gate is taken from the collectors of the input transistors. The propagation delay of the oscillator signal through the gate is minimal because, to switch the output state of the gate, only the state of one of the input transistors (610 or 612) must be changed. The short propagation delay through the gate permits high frequency operation, as well as the ability to program small incremental steps in the center frequency of the oscillator.

Growing community of inventors

Delray Beach, FL, United States of America

Kristen A Hausman