Agfa Graphics Nv

Kris Vangeel

Wim Helsen

Luc H Leenders

Bart Peter Verhoest

Bart J Verlinden

Paul A Delabastita

Koen Vande Velde

Luc Minnebo

Eddi Daems

Erik Van Geel

Upon a substrate subsequent layers of elastic ink are jetted using an ink jet printing system. Each layer is immobilised by a immobilisation step before jetting the following layer. A printing relief is gradually formed to obtain a flexographic printing plate allowing accurate control over the relief and slopes of the printing plates. Use can be made of different inks or immobilisation step to obtain different layer characteristics. Inks can be immobilised using UV curing. The recorded relief of the layers can be measured and corrections can be applied using a feed-back loop. A rejuvenation process for printing plates can be constructed using the described method. An elastic base layer can be provided on the substrate to provide better plate characteristics.

Preparation of flexographic printing plates using ink jet recording

A method and apparatus for creating a print file for printing a 3-D print using a 3-D printing system is described, the 3-D print comprising a plurality of 3-D structures printed on a substrate, each 3-D print structure having a height with respect to the substrate. A two-dimensional source image is input comprising a plurality of image pixel areas. A filtered image is obtained by applying a topographic operator to the source image to generate for every image pixel a representation of a pixel height profile, the pixel height profile corresponding to cross-sections through a 3-D print structure which is to be formed by 3-D printing. Thereby definitions of a plurality of image layers are generated from the filtered image for printing using the 3-D printing system. The print file is output based on the plurality of image layers. The topographic operator has the following property: any cross-section through a solid section of a 3-D structure at a second level in the 3-D print structure which is closer to the substrate than a first level has an area which is equal to or larger than the area of the cross-section of the 3-D structure at the first level.

Method and apparatus for creating 3D-prints and a 3-D printing system

Growing community of inventors

Geel, Belgium

Kris Vangeel