Fanuc Corporation

Kouichi Noda

Soichiro Ide

Nobuaki Aizawa

Takahiko Endo

Ryousuke Taira

A numerical control apparatus includes a command argument determination unit which determines whether a vector is included in an argument of a circular arc interpolation command which is included in command data and a circular arc shape forming unit which forms a circular arc shape based on a machining program, and a start point, an end point, and the vector, which are specified by the argument of the circular arc interpolation command, when the command argument determination unit determines that the vector is included in the argument of the circular arc interpolation command.

Numerical control apparatus enabling specification of a circular arc shape movement trajectory

Numerical control apparatus

A numerical control device includes an operating condition acquisition unit, an executing part acquisition unit, a stopping factor acquisition unit, an acquired information storing unit, a reduction information storing unit, a stopping factor reduction information acquisition unit configured to acquire a reduction information of a stopping time corresponding to a stopping factor information from the reduction information storing unit, and a display unit configured to display the executing part and the stopping factor information and the reduction information of the stopping time corresponding to the stopping factor information.

Numerical control device

A numerical controller obtains a maximum value of an impact produced in a machine during execution of a machining program, identifies an acceleration/deceleration time constant at a point where the maximum value of the impact is generated, based on command data, if the obtained value exceeds a threshold, changes the identified time constant, and recalculates a cycle time of the machining program based on the changed time constant. If the cycle time is within a preset tact time, the changed time constant is stored in advance in association with an identified command block so that it is referred to during the execution of the machining program.

Numerical controller capable of reducing machine load

A numerical control device for a machine tool includes: a timing calculation unit configured to calculate a start timing of a post-reverse movement command by which a position, where the sum of velocities generated in response to a pre-reverse movement command and the post-reverse movement command becomes zero, is equal to a position distanced by an in-position width from the end point of the pre-reverse movement command; and a movement command start unit configured to start the post-reverse movement command in accordance with the start timing calculated by the timing calculation unit.

Growing community of inventors

Minamitsuru-gun, Japan

Kouichi Noda