Jtekt Corporation

Koichiro Matsuhisa

Hiroshi Sumasu

A motor control device includes: a noise reduction unit that sets a PWM count in units of PWM cycles for each PWM cycle in a current control cycle such that a current that flows through a frame ground because of a phase voltage for any one of three phases is canceled out with a current that flows through the frame ground because of a phase voltage for one of the two other phases in each PWM cycle in the current control cycle; and a noise canceling circuit configured to generate a current that is opposite in phase to a current that flows through the frame ground because of a phase voltage for the other of the two other phases in each PWM cycle in the current control cycle.

Motor control device

A motor controller includes a motor drive circuit, a noise cancellation circuit, and a control unit. The motor drive circuit supplies electric power to an electric motor. The noise cancellation circuit includes an RLC circuit, a switch element, and a pull-down resistor. One end of the RLC circuit is electrically connected to a positive terminal of a power supply via the switch element, and the other end of the RLC circuit is electrically connected to a frame ground. A connection point between the RLC circuit and the switch element is electrically connected to a negative terminal of the power supply via the pull-down resistor. The control unit turns ON the switch element for a predetermined time at falling timings of phase voltages output from the motor drive circuit.

Growing community of inventors

Toyota, Japan

Koichiro Matsuhisa