Man Takraf Fordertechnik Gmbh

Man Takraf Fodertechnik Gmbh

Klaus Potenberg

Volkmar Schrader

Dieter Hoffmann

Burkhard Petack

Günter Kunze

Thomas Stenzel

Alexander Ehler

Hans-Joachim Schombel

Manfred John

Gerhard Nies

Bernd Gl&ouml;ckner

Matthias Gnilke

A mining member designed as a cutting roller for a continuously operating surface miner for mining mineral raw materials of high strength. The roller body is equipped for this purpose with mini-disk bits of identical design. Since different conditions occur over the entire width of the roller during the separation of the material from the soil, the roller body is designed correspondingly, and the arrangement of the mini-disk bits is adapted to these conditions. The mini-disk bits in the edge areas are placed at a greater density than are the mini-disk bits () in the middle area. In addition, mini-disk bits are directed obliquely toward the outside as free-cutting bits at the two outer edges of the cutting roller. The height of the mini-disk bits is selected to be such that their individual virtual rolling paths together form a virtual cutting roller body, which comprises a middle cylinder, which is joined on both sides by outwardly tapering frusta. This solution is associated with the advantages that more mini-disk bits are available per unit area in the critical edge areas for separating the material and for cutting the roller free, and the cutting height His smaller there.

Cutting roller for a continuously operating surface miner

A milling roller module for a surface miner, includes a milling roller operating with undershot for loosening the material from the block being mined, a support frame for fastening the milling roller to the surface miner, and a takeup chute for supporting the intermediate conveying of the loosened material in the area of the milling roller and for transferring the material to the downstream discharge belt in a specific manner. The drives are placed into the milling roller and the feed lines are led into the milling roller together with the support frame for fastening the milling roller from the side in the upper third of the milling roller diameter. As a result, it is possible to perform mining operations up to a cutting depth that is equal to half the roller diameter. A takeup chute is provided to transfer the material from the milling roller onto the downstream discharge belt in a specific manner. This takeup chute is also used to limit the conveying space in the area of the milling roller together with ring segments arranged on it and on the milling roller and thus to reduce losses of material.

Milling roller module for a surface miner

Growing community of inventors

Munich, Georgia

Klaus Potenberg