Toyota Jidosha Kabushiki Kaisha

Kiyomi Nagamiya

Iwao Maeda

Akihiro Ueda

Masaaki Yamaoka

Yasuhiro Tajima

Masashi Yamashita

Yoshikazu Motozono

Naoto Shibata

Haruki Oguri

Masayoshi Taki

Naoto Hasegawa

Yasushi Araki

Satoshi Aoyama

Kazunori Kagawa

Kunihiko Jinno

Mitsuru Nakamura

Seiji Mizuno

Masafumi Uchihara

Shigeki Matsumoto

Koji Nishida

Yoshihiro Maekawa

Hirohisa Onome

Shinya Nishigaya

When it is judged that a downward slope segment exists in a scheduled traveling route, the control device of a hybrid vehicle sets a target remaining capacity SOC* in a pre-use segment in a downward slope segment and the downward slope segment to a 'low-side remaining capacity Sd which is &#x394;Sd smaller than a standard remaining capacity Sn.' Furthermore, when it is presumed that a rise amount of a remaining capacity by an extended regeneration control is large in the pre-use segment and the downward slope segment, the target remaining capacity SOC* is set to a 'low-side remaining capacity Sd which is a sum of &#x394;Sd and &#x394;Ssmaller than the standard remaining capacity Sn.'

Control device for hybrid vehicle

When a vehicle is in an accelerator off state and satisfies a free-run condition, a regeneration control unit performs free-run control on the vehicle so that the amount of regenerative electric power is decreased. The regeneration control unit sets a free-run prohibited zone between a starting point of a regeneration enhancement zone and a position that is located in front of and separated by a determination distance from the starting point.

Vehicle controller

An azimuth detecting device mounted in a mobile object and having: a geomagnetic sensor; GPS signal receiving means; and measuring means for measuring a position of the mobile object by using a GPS signal, the azimuth detecting device being characterized in calculating a gain correction amount by means of a method of least squares, using an output value of the geomagnetic sensor when a level of the GPS signal received by the GPS signal receiving means is lower than a predetermined level, and calculating a declination correction amount and/or an inclination correction amount on the basis of information obtained from the GPS signal and correcting the output value of the geomagnetic sensor, when the level of the GPS signal is at least the predetermined level.

Azimuth detecting device and azimuth detecting method

To provide an attitude-angle detecting apparatus, which detects an attitude angle of a mobile object during movement with good accuracy by correcting an output value from an acceleration sensor, and to provide a method for the same. It is characterized in that it comprises an acceleration sensor for measuring an acceleration being applied to a mobile object, a yaw-rate sensor for measuring a yaw rate of the mobile object, a speed sensor for measuring a speed of the mobile object, a mobile-component acceleration calculating means for calculating an actual acceleration from the speed, calculating a centrifugal force from the yaw rate and the speed and calculating a mobile-component acceleration, a resultant force of the actual speed and the centrifugal force, and an attitude-angle calculating means for calculating an attitude angle from a gravitational acceleration, which is obtainable by correcting the acceleration with the mobile-component acceleration.

Attitude-angle detecting apparatus and attitude-angle detecting method

A mobile object position estimation apparatus mounted in a mobile object includes a first estimation mechanism for estimating the mobile object position based on the outputs from an inertial navigation sensor device (acceleration sensor, and yaw rate sensor, or the like) mounted on the mobile object, a storage for storing map information including at least node information, a second estimation mechanism for estimating the mobile object position based on a predicted path of traveling of the mobile object predicted from the node information, and a synthesis mechanism for determining the final estimated mobile object position by synthesizing the mobile object position estimated by the first estimation mechanism and the mobile object position estimated by the second estimation mechanism.

Mobile object position estimation apparatus and method

A device for measuring a position of a mobile station according to the present invention comprises: first measuring means for measuring the position of the mobile station based on observed data of signals from satellites using a one-epoch measuring method; second measuring means for measuring the position of the mobile station using previous determination result of the position of the mobile station and speed information representative of a speed of the mobile station; third measuring means for measuring the position of the mobile station using solutions of variables derived from previous determination results of the first or second measuring means; and controlling meansfor selecting one of the respective measuring means which is to execute its measuring process; wherein if reliability of the determination result of the selected measuring means is lower than a predetermined reference value, the controlling means selects another measuring means to make it execute its measuring process.

Device for measuring a position of a mobile station

In a mobile-unit positioning device, phases of pseudo noise codes carried on satellite signals from satellites are observed at a mobile unit to measure a position of the mobile unit. A pseudo distance between one of the satellites and the mobile unit is measured for every satellite during a stop of the mobile unit using an observed value of the phase acquired during a stop of the mobile unit. An error index value indicating an error of the measured distance is computed based on the distances measured at points in time during a stop of the mobile unit. A weighting factor is determined based on the index value computed for every satellite. A weighted positioning computation using the determined weighting factor is performed to determine a position of the mobile unit during movement using an observed value of the phase acquired during movement.

Mobile unit positioning device

A positioning systemincludes a positioning unitconfigured to perform position estimation based on radio signals from artificial satellites and an autonomous navigation unitconfigured to perform position estimation by autonomous navigation. In the positioning systemthe positioning unitand the autonomous navigation unitestimate the position of a mobile body in cooperation with each other; and when the number of the artificial satellites available is less than three, the positioning unit determines a point in an area calculated based on the radio signals which point is closest to an inertial-navigation-based position calculated by autonomous navigation, and uses the determined point as a satellite-based position estimated based on the radio signals.

Positioning system, positioning method and car navigation system

A fuel cell control apparatus for controlling the supply amount of oxidizing gas to a fuel cell for producing electric energy by reaction between fuel gas and oxidizing gas includes a smoother for smoothing the output related quantity of the fuel cell, and an oxidizing gas feed determining device for determining the supply amount of the oxidizing gas on the basis of the output related quantity smoothed by the smoother, and therefore when controlling the amounts of the fuel gas and oxidizing gas depending on the output demand of the fuel cell, the substantial power generation efficiency is enhanced and the output is stabilized at the same time.

Fuel cell control apparatus

A control apparatus for a reformer and a method of controlling the reformer are provided. The reformer gasifies a reformate fuel by a reforming reaction, supplies the obtained reformate gas to an energy converter to convert the reformate gas into energy of another form, and heats the reformate fuel by burning emission containing unreacted flammable gas produced in the energy converter. The control apparatus comprises a reforming amount assessing device for assessing the amount of the reformate fuel to be gasified, and an emission amount assessing device for assessing the amount of emission to be supplied into the reformer on the basis of the assessed amount of reformate fuel. When using the unreacted hydrogen gas generated in a fuel cell for heating the reformate fuel, the unreacted hydrogen gas and combustion aid gas can be controlled so that the reformate fuel is heated properly.

Control apparatus for reformer and method of controlling reformer using control apparatus

A fuel reforming apparatus has a heating device, a reformer, and a CO oxidizing device. The heating device has a burning device for oxidizing fuel for burning with air and a vaporizing device for vaporizing the raw fuel. The control device for the fuel reforming apparatus has a raw fuel quantity determinator and a target temperature setting means for setting the target temperature of the raw fuel. The raw fuel quantity determinator determines a quantity of raw fuel supplied to the heating device. On the basis of the quantity of raw fuel supplied to the heating device by the determination of the raw fuel quantity determinator, the target temperature setting means sets a target temperature of the raw fuel. The heating device then heats the raw fuel to the predetermined target temperature by the control of the above-mentioned control device.

Control device for a fuel reforming apparatus

A control system for a fuel cell to output an electric energy by a reaction between a fuel gas and an oxidizing gas. The control system comprises a humidifier for decreasing the humidification of the fuel cell when the pressure in the fuel cell is high, and for increasing the humidification of the fuel cell when the pressure in the fuel cell is low.

Control system for fuel cell

A carbon monoxide reducing device supplies oxygen to a reformate gas obtained through a reforming reaction so as to oxidize carbon monoxide contained in the reformate gas by means of the oxygen and thereby reduces a concentration of carbon monoxide contained in the reformate gas. This carbon monoxide reducing device is equipped with an oxygen supply amount controller designed to oxidize CO. The oxygen supply amount controller controls an amount of oxygen supplied to oxidize carbon monoxide contained in the reformate gas based on an amount of supply of fuel contributing to the reforming reaction. Thereby, the amount of oxygen for oxidizing carbon monoxide contained in the reformate gas is adjusted appropriately, and a high-quality reformate gas can be obtained.

Carbon monoxide reducing device for reducing carbon monoxide in a reformate gas

A control apparatus can maintain a substantially constant temperature of a reforming reaction in which a partial oxidation reaction occurs. The control apparatus can be used for a reformer that reforms reformats fuel into fuel by an endothermic reforming reaction and a partial oxidation reforming reaction. The amount of oxygen supplied for the partial oxidation reaction is determined based on an amount of the raw material and on theoretical endothermic values and exothermic values of the respective reforming reaction and partial oxidation reaction.

Growing community of inventors

Nissin, Japan

Kiyomi Nagamiya