Juniper Networks, Inc.

Kenneth Richard Powell

Ashok Krishnamurthi

Ross Heitkamp

Michael Beesley

Michael Armstrong

Mike M Wu

A two wire serial bus is connected between different circuit boards in a complex electrical system. The two wire serial bus may be used to receive status information about each of the circuit boards in the system. A master control processor on one of the circuit boards controls which of the other circuit boards are active on the serial bus. Each of the non-master circuit boards includes a series of switches that electrically isolate or connect portions of the two wire serial bus from one another. Through the series of switches, both the master control processor and processors local to each of the other circuit boards may simultaneously access different portions of the serial bus.

Multi-master and diverse serial bus in a complex electrical system

A network device includes redundant buses, redundant master controllers, and slave controllers. Each of the master controllers connects to a corresponding one of the buses. One of the master controllers acts as an active master and the other master controllers act as standby masters. The active master commences a bus cycle that includes an address interval and a data interval, provides a destination address on the corresponding bus during the address interval, and transmits or receives a command or data during the data interval. The slave controllers connect to the bus, detect commencement of the bus cycle, sample the destination address from the bus a predetermined amount of time after commencement of the address interval, and transmit or receive a command or data during the data interval.

Reliable and redundant control signals in a multi-master system

A debugging and diagnostic system allows a developer to receive low-level diagnostic information from multiple processors in a complex electrical system. A bus connects a master processor to the processors to be debugged via corresponding receiver/driver circuits. The receiver/driver circuits receive serial information from the processors and transmit it to the bus. The master processor controls the receiver/driver circuits through a control logic circuit.

Growing community of inventors

Palo Alto, CA, United States of America

Kenneth Richard Powell