Mitsubishi Denki Kabushiki Kaisha

Isuzu Motors Limited

Nabtesco Corporation

Nippon Steel & Sumikin Stainless Steel Corporation

Kenji Hattori

Eiichiro Ishimaru

Masaharu Hatano

Koki Matsumoto

Ichirou Minato

Fumiaki Uno

Hiroshi Ozawa

Provided is a stainless steel substrate for a solar cell, the stainless steel substrate including, by mass %, Cr: 9% to 25%, C: 0.03% or less, Mn: 2% or less, P: 0.05% or less, S: 0.01% or less, N: 0.03% or less, Al: 0.005% to 5.0%, Si: 0.05% to 4.0%, and a remainder including Fe and unavoidable impurities, in which an oxide film containing (i) AlOin an amount of 50% or more or containing (i) AlOand (ii) SiOin a total amount of 50% or more is formed on a surface of stainless steel having a composition which contains Al: 0.5% or more and/or Si: 0.4% or more and satisfies the following expression (1).Cr+10Si+Mn+Al&#x3e;24.5&#x2003;&#x2003;(1)

Stainless steel substrate for solar cell having superior insulating properties and low thermal expansion coefficient and method of producing the same

An object of the present invention is to allow a vehicle to run in the case where an air compressor connected to an input port fails so as to cause air leakage from the location of the failure, by preventing air in a parking brake circuit from leaking from the failure location through a bleed air flow path. In order to achieve the object, a multi-protection valve includes: a communication passage for communicating between an input chamber and a service output port so as to bypass a pressure control valve provided in correspondence with the service output port, the communication passage having a check valve for preventing air from flowing from the service output port into the input chamber and a throttle for restricting the air flow rate; and a bleed air flow path for communicating between the input chamber and the parking output port so as to bypass pressure control valves, the bleed air flow path having a second check valve for preventing air from flowing from the input chamber to the parking output port. The multi-protection valve further includes a third check valve provided between the input chamber and an input port to prevent air from flowing from the input chamber to the input port.

Multi-protection valve

There are provided a drive unit having a connection part while driving a motor , a control unit having a connection part while receiving a command from a host controller and sending a command to the drive unit , a rack for providing a back panel having connected parts for removably making electrical connection to the connection parts while accommodating the control unit and the drive unit , and a DC voltage conversion part for converting a DC voltage into an output using an AC voltage as an input while being provided in the back panel , and the drive unit is provided with a capacitor while being connected to an output of the DC voltage conversion part , and an inverter for converting the DC voltage into an AC voltage based on the command.

Servo control system

Growing community of inventors

Tokyo, Japan

Kenji Hattori