Jtekt Corporation

Keita Goto

Akira Makiuchi

Ikuya Kato

Yoshihiro Somyo

Kenichi Yabuki

The positions of at least three points, which are circumferentially, and equiangularly, offset from each other, of a peripheral face of a workpiece set on a rotary table are measured using a position detection probe. The amount of runout of the axis of the workpiece and a phase position of the workpiece, at which the runout amount is largest, are calculated from the measured positions of the equiangularly offset points. The rotary table is turned to set the largest runout phase position of the workpiece in a position opposed to a workpiece contact of a centering apparatus. The relative positions of the workpiece and a position detection block are calculated using the position detection probe. The workpiece is centered by moving a centering shaft member of the centering apparatus such that the workpiece contact pushes the workpiece by a distance corresponding to the runout amount.

Growing community of inventors

Okazaki, Japan

Keita Goto