Matsushita Electric Works, Ltd.

Kazuhiro Nishimoto

Katsunobu Hamamoto

Masahiro Yamanaka

Tokushi Yamauchi

Toshiya Kanja

Yukio Yamanaka

Hiromitsu Mizukawa

An inverter controller dives an inverter to operate at a switching frequency selectively from one of a preheating frequency (f), a starting frequency (f), and a lighting frequency (f) which are different from each other, thereby giving a preheating mode, a starting mode, and a lighting mode. A reset means is provided to make the starting mode upon lowering of a voltage supplied to the inverter below a first threshold, while an inverter stop means is provided to stop the inverter upon detection of abnormality of a discharge lamp. A timer generates a signal determining the start of the preheating, starting, and/or lighting modes, and generates a reset signal disable signal for disabling the reset means, an inverter stop disable signal for disabling the inverter stop means. The inverter controller includes a frequency sweep means for varying the switching frequency gradually from the starting frequency to the lighting frequency. The timer disables the reset means only during a period starting from the selection of the preheating frequency and ending when the switching frequency varies to the lighting frequency, and disable the inverter stop means only during a period starting from the selection of the preheating frequency and ending when the switching frequency begins to vary from the starting frequency to the lighting frequency.

Discharge lamp ballast device and lighting appliance

A ballast circuit for a discharge lamp capable of protecting the circuit when the lamp reaches its end of life with a cost effective circuit arrangement. The circuit includes a DC voltage sensing network for sensing a DC voltage which appears as a consequence of the lamp reaching its end of life. Upon the sensed DC voltage exceeding a threshold, a control is made to limit or stop supplying an output power to the lamp for protecting the ballast circuit from an otherwise generating excessive current. The sensing network is composed of a DC sensing capacitor and a resistor which are connected in circuit outside of a resonant circuit responsible for generating a high frequency voltage to operate the lamp. Thus, the DC sensing capacitor can be kept free from the high voltage generated by the resonant circuit and be of less cost for reducing a manufacturing cost.

Ballast circuit for operating a discharge lamp

A power supply with a full-wave rectifier and a chopper having an inductor and a transistor connected in series across the rectifier. The transistor is switched on and off providing an interrupted voltage which is applied across a smoothing capacitor, via a blocking diode, to produce a smoothed DC voltage for driving a load. When the transistor is turned on, current from the rectifier is drawn through the inductor. When the transistor is turned off, the current through the inductor is conducted, in a positive direction, to the smoothing capacitor. The inductor and parasitic capacitance inherently present in the chopper create oscillations which allow current to flow through the inductor in a negative direction. A controller turns the transistor on at a time when the current flows in the negative direction and turns the transistor off after a predetermined on-period so as to release the current through the inductor, thereby causing the current to first flow in the negative direction and then in the positive direction through the inductor during the on-period. An input current wave shaping circuit is provided so that for each on-period, the amount of current flowing continuously through the inductor in the negative direction occurring immediately after the turning on of the transistor is less than the amount of current flowing through the inductor in the positive direction.

Growing community of inventors

Kashihara, Japan

Kazuhiro Nishimoto