Andreas Stihl Ag Co. Kg

Jörg Präger

Heinrich Leufen

Klaus Geyer

David Fallscheer

Andreas Neubauer

Rolf Walter

Steffen Bantle

Michael Link

Martin Kiesner

Erik Ames

In a method for operating an internal combustion engine for adjusting a desired fuel/air mixture, wherein the rotary speed is determined by an operating curve based on a fuel/air mixture composition, wherein the operating curve has ascending and descending branches and a maximum, wherein a lambda value is smaller than 1 on the descending branch, it is first determined by statistic evaluation whether the operating point is on the ascending or descending branch. In a second method step, when the operating point is not on a desired branch of the operating curve desired as a starting point for a third method step, at least one operating parameter is changed until the operating point is positioned on the desired branch. In a third method step, the maximum of the operating curve is determined. Based on the determined maximum, the desired operating point of the internal combustion engine is then adjusted.

Method for operating an internal combustion engine

A portable work apparatus has a combustion engine for driving a work tool. An air/fuel mixture is supplied to the engine via a carburetor which is provided with an electrical heating element for heating to a given temperature. The heating element is connected to a switch via which electrical energy, which is provided by a generator driven by the engine, is supplied. When a given temperature is exceeded, the switch interrupts the energy supply. To achieve an exact temperature control, the ohmic resistance value of the heating element is stored in a memory in dependence on the temperature. The current flowing through the heating element and the voltage drop at the heating element are measured and the instantaneous resistance of the heating element is calculated therefrom. This calculated value is compared to the value stored in the memory to open or close the switch in dependence on the comparison.

Handheld work apparatus having a control unit for an electric heating element

A handheld work apparatus has a drive motor which drives a work tool and a generator. The work apparatus has a first electrical load and a connectable second electrical load. The generator provides the electrical power for the simultaneous operation of the two loads. The work apparatus has a control unit for controlling the power supplied to the first electrical load. In order to supply approximately the same power independent of voltage fluctuations, a voltage monitoring circuit is provided which, in a first operating state, sets a first signal sequence for operating the first load and, in a second operating state, sets a different second signal sequence for operating the first load. The mean power of the first signal sequence and that of the other second signal sequence are approximately equal.

Handheld work apparatus having a control unit for operating an electric load

Growing community of inventors

Winnenden, Germany

Jörg Präger