Baker Hughes Corporation

Tam International, Inc.

John Thurston

James R Korte

Steve Rosenblatt

Anthony P Foster

Kent A Evans

Dustin D Ellis

James Edward Goodson

Caleb Kelley

A packer includes a tubular mandrel. The packer includes a first end cap, the first end cap coupled to the mandrel. The packer includes a backup mechanism coupled to the first end cap. The packer includes a swellable elastomeric body positioned about the mandrel abutting the first end cap. The swellable elastomeric body is positioned at least partially between the mandrel and the backup mechanism. The swellable elastomeric body is positioned to not cover the entire outer surface of the backup mechanism.

High pressure swellable packer

A polymer composition includes a base polymer comprising a hydrocarbon rubber, an acrylic copolymer, and a refined oil in which the acrylic polymer is dispersed. The polymer composition is swellable when treated with an aqueous medium, non-aqueous medium, or both. A sealing element for a flow channel includes an expandable section filled with a swellable composition that swells when treated with a swelling material. The swellable composition includes the polymer composition, and the swelling material may be aqueous, non-aqueous, or both.

Polymer composition, swellable composition comprising the polymer composition, and articles including the swellable composition

Through the combination of at least two polymer families, and the optimization of other components, a rubber compound has been developed for use in downhole applications that will swell in water-based fluids. A cellulose component, such as carboxy methyl cellulose (CMC), is used together with an acrylate copolymer (AC) that can increase the swelling capacity of an acrylonitrile butadiene rubber (NBR) in water. The amount of swelling achieved depends on physical boundaries and limitations, the salinity of the water, and the temperature.

Water swelling rubber compound for use in reactive packers and other downhole tools

A swelling packer is covered with a material that is preferably in a tubular form and slipped over the swelling element to be shrink fit with applied heat. The material is formulated to break down at temperatures slightly below the expected downhole temperatures so that ideally the packer has about 48 hours of swelling delay which is normally a time period long enough to allow it to be properly located without it swelling so much as to cause it to be damaged by running in. Various polymers can be used to make an imperious covering for run in that on the way starts to break down. Ideally the material for the cover disappears about the time of sealing or shortly thereafter.

Growing community of inventors

Houston, TX, United States of America

John Thurston