Ford Global Technolgoies, LLC

John Randall Armstead

Stephen Michael Cicala

Conor Edward Sullivan

Bradley Dean Riedle

Alexander Phillip McDonnell

Derek Kinch

Timothy Fedullo

Cory Benson LaRoche

Dongdong Dee Li

Brian Michael O'Neil

Kendrick Morrison

Pramod Kumar Jain

Joseph Scott Slayton

Ravindra Velamakanni

Abhay Mane

A transmission includes a selectable one-way clutch with active and passive states. Successful transition from the active state to the passive state is only possible when there is no torque tending to cause overrunning. After commanding a transition from the active state to the passive state, a controller partially engages a first friction clutch to induce a torque tending away from overrunning until a lash crossing is detected. Then, the controller releases the first clutch and partially applies a second clutch to induce a torque toward overrunning. When slip is detected, indicating successful achievement of the passive state, the second clutch is released.

Transmission with selectable one-way clutch

A transmission includes a selectable one-way clutch with an active state and a passive state. To avoid occupant discomfort and hardware damage, transitions from the passive state to the active state must only be commanded when no or very little slip is present across the selectable one-way clutch. Several methods are presented to eliminate slip, depending on vehicle speed. When the vehicle is stationary, full engagement of a clutch that causes slip to be proportional to vehicle speed eliminates slip. When the vehicle is moving backwards, partial engagement of the above clutch eliminates slip. When the vehicle is moving forwards, full engagement of all but one clutch of a tie-up condition and partial engagement of the remaining clutch of the tie-up condition brings the vehicle to a stop and eliminates slip.

In order to pre-stage a clutch piston in preparation for clutch engagement, a controller commands a high current to a Casting Integrated Direct Acting Solenoid (CIDAS) valve. This staging is performed in two distinct phases wherein the current is higher in the first phase than in the second phase. Staging the piston in this manner reduces the staging time and reduces the variability of the staging time. The duration of the first phase may be adjusted based on a number of parameters including, the length of a preceding engine off period, the number of clutch applications since the engine off period, a fluid temperature, and a length of time since a preceding engagement of the clutch.

Two-phase transmission clutch staging

A vehicle includes a transmission having a first neutral with a first combination of engaged clutches and a second neutral with a second combination of engaged clutches. The second neutral has more engaged clutches than the first neutral. A vehicle controller is programmed to, in response to a request to shift from the first to the second neutral and a failed-on clutch being detected, inhibit the shift to remain in the first neutral.

Method and control for operating transmission during clutch failure

A vehicle includes a transmission having a first neutral with a first combination of engaged clutches and a second neutral with a second combination of engaged clutches. The first neutral has more engaged clutches than the second. A controller is programmed to, in response to a request to shift from a drive gear to the first neutral and a clutch of the drive gear being failed-on, shift to the second neutral.

Method and control for operating transmission during clutch failure when shifting from gear to neutral

A transmission includes a latch valve with latched and de-latched states. In the de-latched state, the latch valve directs a control pressure to a clutch apply circuit. In the latched state, which is entered in response to a control pressure higher than a latch pressure, the latch valve directs a line pressure to the clutch apply circuit. A controller manages the transition from latched to de-latched differently depending upon the transmission input torque and gear state. At high transmission input torque, the controller first reduces the control pressure to rapidly accelerate a spool in the latch valve, and then increases the control pressure to prevent clutch slip. At low torque, the controller reduced the pressure to an intermediate value during the transition and then reduces it again. At moderate torques, the controller reduces the pressure directly to a target pressure in a single step.

Growing community of inventors

Farmington Hills, MI, United States of America

John Randall Armstead