Rockstar Consortium US LP

Nortel Networks Corporation

Rockstar Bidco, LP

Rpx Clearinghouse LLC

John J Osswald

Michael K Poon

Simon P Parry

Robert Friskney

Florin S Balus

Nigel Lawrence Bragg

Michael Suiping Chen

Mirza Arifovic

Michael Chen

A node comprises a first communications interface to a customer network element, where the first communications interface is part of a group of communications interfaces to the customer network element to provide failover support. The node further includes a network interface to communicate over a trunk group to other nodes, where the trunk group includes a primary trunk and a secondary trunk. Just one of the primary and secondary trunks is active for communicating data units.

Communicating data units in a communications network that provides failure protection

After statically provisioned paths are created through an Ethernet network, trunks may be created to extend along those paths. The trunks extend between pairs of NNI interfaces on either end of the path, and Ethernet OAM may be run over the trunks to detect connectivity along the paths. Service instances and service groups may be provisioned over particular paths through the network. Each service instance/service group is associated with a trunk and the Ethernet OAM service on the trunk may be used to provide Ethernet connectivity OAM for the service instance/service group. Upon detection of a failure on the trunk, the service instances/service groups associated with the trunk may be caused to failover to an alternate path through the network. Thus, a single Ethernet OAM service instance may be used to provide connectivity verification so that connectivity detection does not need to be performed on each individual service instances/service group.

Method and apparatus for increasing the scalability of the ethernet OAM

An Ethernet switch for use in an Ethernet network comprises a set of ingress ports for receiving data frames and a set of egress ports. A memory is associated with each ingress port and stores forwarding information indicating one or more of the egress ports to which data frames received by that ingress port should be forwarded. A control or management interface receives information about a network connection established, or to be established, through the switch. A switch controller causes forwarding information to be stored in a memory associated with a first ingress port which the network connection will use, on the basis of the received information about a network connection. Forwarding information is not stored in a memory associated with a second of the set of ingress ports which the network connection will not use. Preferably, the switch controller causes forwarding information to be stored only in a memory associated with the first ingress port which the network connection will use and not to be stored in a memory associated with any of the other ingress ports.

Forwarding table minimisation in ethernet switches

A system for originating connectivity fault management (CFM) frames on non-CFM aware switches is disclosed. In the disclosed system, an OAM (Operations Administration and Management) proxy networking device connected to a core Ethernet network operates with one or more CPE (Customer Premises Equipment) devices to which it is communicably connected to support CFM out to the CPE devices without requiring that the CPE devices themselves implement CFM functionality. The OAM proxy networking device generates Connectivity Check (CC) frames, Loopback reply frames, and Linktrace reply frames for MEPs (Maintenance End Points) or MIPs (Maintenance Intermediate Points) contained in communication ports on the CPEs. These CFM frames generated by the OAM proxy networking device are then sent within messages from the OAM proxy networking device to the appropriate CPE. When the CPE device receives a message from the OAM proxy networking device containing one of these CFM frames, it checks the operability of a communication port indicated by the message. If the port is operable, the CPE device extracts the CFM frame from the message and originates it through the OAM proxy networking device into the core Ethernet network. The OAM proxy networking device further operates to process Connectivity Check frames received from the core Ethernet network and addressed to the CPE devices by maintaining an MEP connectivity database. As a result, these received Connectivity Check frames are dropped without forwarding to the CPE devices.

Method and system for originating connectivity fault management (CFM) frames on non-CFM aware switches

Method and apparatus for increasing the scalability of Ethernet OAM

Growing community of inventors

Northbridge, MA, United States of America

John J Osswald