International Business Machines Corporation

John C Bartlett

Donald Wayne Stafford

Cary Patterson Ravitz

Steven L Applegate

Stanley Dyer

Brian Wesley Damon

Donald Fred Croley

Frank J Horlander

Kenneth E Edds

Alan E Bohnhoff

David W Holcomb

Wear on the elements (5) of a printhead (3) is spread by shifting the region of use of the printhead line by line. Font (13) provides information as to whether any character in a line employs the upper three pels or the bottom three pels of a line. For each line which can be printed from different shift positions of the printhead, selection logic controls paper feed (15) to index platen (9) to the least used of a shifted position of printhead. Only those electrodes over the print line in each shifted position are used for printing. This distributes wear without requiring any special ribbon feed. The three pel height is at least as wide as the serifs on most characters, which avoids some electrodes being used for the serifs of given characters in more than one shift position.

Printhead shifting for wear distribution

Ribbon (22) in thermal printing has an outer layer which adheres to printed characters at intermediate temperatures, lower than printing temperatures. The printhead (7) has a column of electrodes (9) which sweep across the character area. Lift-off is accomplished by the pattern control (40) controlling the current source (38) to provide rapid, square wave pulses displaced in phase 180 degrees at adjoining electrodes (9). The high level of the pulses is about that of the level at printing, and the pulses are sufficiently rapid so that their net effect is to raise the outer layer ribbon (22) to the intermediate temperature. At areas corresponding to underlines of characters, duration of the up period is longer. Good, long term reliability is achieved by the significant erase level being very close to the print level.

Drive for thermal printing lift-off correction

Growing community of inventors

Lexington, KY, United States of America

John C Bartlett