Zilker Labs, Inc.

Intersil Americas Inc.

John A Wishneusky

Kenneth Wilson Fernald

James Warren Templeton

In one set of embodiments, a power management system comprises two or more devices, such as POL devices, configured to transmit and receive data over a shared bus, such as an I2C bus, according to the bus protocol of the shared bus. Each device may be configured with at least one respective address register, which may be programmed with an address uniquely identifying the device, and a mask register that may be configured to mask select bits of the respective address register, thereby enabling the device to identify device groups. In one embodiment, one of the devices identifying itself as a master device may distribute information to any of the other devices by transmitting the information, which may include commands and/or data, to itself, in effect targeting the address programmed into its own address register. The devices on the shared bus may be configured to monitor the bus for events, and respond to each event according to the requirements inherent within a transmitted command, thereby performing the necessary tasks to enable power management functions without the need for interconnecting analog signal lines.

Method for using a multi-master multi-slave bus for power management

A Device-to-Device Communication Bus protocol may facilitate transmission of a two to four byte packet by any device sharing the bus. All devices on the bus may monitor the bus, receiving all packets transmitted by other devices and recognizing when they may initiate transmission. The first byte of the packet may be an Address byte uniquely identifying the sender and allowing hardware arbitration to uniquely select one of any number of senders who may wish to transmit and begin transmission simultaneously. Arbitration may take place during transmission of the Address byte, with the transmitting device monitoring a bus bit value as it is transmitting the Address byte. If the data value observed by the transmitting device doesn't match the transmitting device's desired transmit value, the transmitting device may recognize loss of arbitration and suspend transmission to retry once the packet is complete. The receive function in every device may accept the packet as a normal received packet. The arbitration scheme may also include a fairness mechanism to insure one or several devices cannot monopolize the bus.

Device-to-device communication bus for distributed power management

A power management system may comprise two or more POL regulators configured to transmit and receive data over a shared bus according to either a proprietary or a common bus protocol. Each POL regulator may be identified by a unique address that is part of an address group, and may be configured via pin strapping to be able to perform a variety of power management functions. Any one of the POL regulators within the address group may become a bus master and transmit information to the shared bus by addressing itself. The other POL regulators in the address group may monitor the shared bus for events, and may respond to the transmitted information according to their address, their configuration, and the transmitted information. The response may include the POL regulators performing one or more power management functions, including adjusting their respective output voltages. The POL regulators may respond to each event according to the requirements corresponding to the event, thereby performing the necessary tasks to enable power management functions without the need for interconnecting analog signal lines and without being explicitly controlled.

Integrated multi-function point-of-load regulator circuit

Power management system using a multi-master multi-slave bus and multi-function point-of-load regulators

A power management system may be configured to allow digital information relating to the power management functions of sequencing and fault spreading to be passed between POL regulators using a standard multi-master multi-slave interface such as IC bus interface or SMBus interface. POL regulators may be configured via pin strapping, and coupled to a serial data bus where they may monitor bus transactions initiated by other similar POL regulators. Each POL regulator may respond to the bus transactions initiated by other POL regulators according to its configuration, and may perform a variety of tasks associated with sequencing and fault spreading in addition to regulating its own voltage output. When configured with a standard multi-master/multi-slave interface such as an IC bus interface or SMBus interface, the POL regulators may report information to multiple other POL regulators while maintaining compatibility with non-POL devices also connected to the bus.

Growing community of inventors

Austin, TX, United States of America

John A Wishneusky