Texas Instruments Corporation

Jiann Liu

Mark Stephen Rodder

Amitava Chatterjee

Cecil J Davis

Lee M Loewenstein

Clarence W Teng

Purnendu K Mozumder

Ih-Chin Chen

A contact hole (32) is formed through a conducting layer (28). The conducting layer (28) is then undercut (34 and 36). An insulating layer (40) is formed in the contact hole (32). A contact (42) is then formed within the contact hole (32).

Self-aligned contact through a conducting layer

A method for forming a dual-gate transistor includes the step of forming a gate oxide layer (18) over two transistor regions provided by a P-tank (12) and an N-tank (14). This is followed by depositing a layer of in-situ doped poly (20) and then masking off a portion of the poly layer (20) overlying the P-tank (12). This is then followed by diffusion of P-type impurities into the portion of the poly layer (20) overlying the N-tank (14) associated with the P-channel transistor. This is a process required for forming a DRAM memory. Utilizing the same oxide mask (22), a threshold implant is formed into the N-type (14).

Method for forming dual-gate CMOS for dynamic random access memory

A process for forming a titanium disilicide conductive layer on the upper surface of a poly gate is implemented within a self-aligned contact process. In this process, the poly layer is first formed followed by sputtering thereon of a refractory metal layer such as titanium. This is then covered by a nitride or oxide capping layer (18). A gate electrode mesa is then formed which will then have a layer of oxide (26) deposited thereon by an LPCVD technique. The temperature of this oxide deposition is such that the refractory metal layer (16) will react with the underlying poly layer (14) to form a titanium disilicide layer (28). This requires the temperature to be in excess of 600.degree. C. for this step. Thereafter, the layer (26) will be utilized to form a sidewall spacer region.

Process for forming a metal-silicide gate for dynamic random access

A DRAM array (100) having reduced bitline capacitance. The DRAM cell includes a pass transistor and a storage capacitor (150). An isolation structure (108) surrounds the DRAM cell. The bitline (140) is connected to a source/drain region (120b) of the pass transistor using a first polysilicon plug (112). A second polysilicon plug (110) connects the storage capacitor (150) to the other source/drain region (120a&c) of the pass transistor. Both polysilicon plugs (110, 112) extend through an interlevel dielectric layer (116) to one of the source/drain region (120a-c) of the pass transistor, but neither extends over the isolation structure (108). If desired, either the storage capacitor (150) or the bitline (140) may be offset from the source/drain regions (120a-c).

Capacitor over bitline DRAM cell

A design to attain a pass transistor for a 256 Mbit DRAM part. The transistor having a gate length of about 0.3 .mu.m, a t.sub.ox of about 85 .ANG., which is much thicker than the .about.65 .ANG. t.sub.ox for 0.25 .mu.m logic technology, a V.sub.WL of 3.75 V, a V.sub.sub of -1 V, arsenic LDD and a boron concentration in the channel region of about 2.7.times.10.sup.17 /cm.sup.3 are the desired technological choices for 256 Mbit DRAM devices.

Pass transistor for a 256 megabit dram with negatively biased substrate

A processing apparatus and method for providing a process module with a low pressure, low energy ion implanter and a remote microwave plasma generator and a source of thermal energy, which is adapted to receive wafers for processing in a low pressure carrier.

Growing community of inventors

Irving, TX, United States of America

Jiann Liu