At&t Bell Laboratories

Jennifer Aspell

Neal S Bergano

John L Zyskind

James W Sulhoff

Richard G Smart

Bruce M Nyman

In an embodiment for obtaining accurate noise figure measurements for any degree of saturation of an optical amplifier, a polarizer is located at the output of the optical amplifier. The amplified spontaneous noise (ASE) produced by an optical amplifier is not polarized, whereas the amplified signal has a well defined state of polarization which is preferably linear. If the amplified signal is not linearly polarized, it can be rendered linearly polarized in one direction by means of a polarization controller located downstream of the polarizer. By setting the polarizer to have its state of polarization orthogonal to that of the linearly polarized amplified signal, the spectral density of the ASE from the polarizer can be measured without associated distortion due to the signal. By sequentially adjusting the polarization controller to minimize and then maximize the signal which it passes, sequential measurements of the ASE spectral density and gain of the optical amplifier can be obtained. Continuous measurements of the ASE can be obtained by placing a splitter such as a 3dB coupler between the polarizer and the optical amplifier and setting the state of polarization of the polarizer to be continuously orthogonal to the state of polarization of the amplified signal from one leg of the splitter. At the same time, a signal from the other leg of the splitter which consists of ASE noise plus the amplified signal can be used to obtain the gain of the optical amplifier. From the measurements of the ASE with and without the amplified signal, the noise figure of the optical amplifier can be calculated.

Growing community of inventors

Tinton Falls, NJ, United States of America

Jennifer Aspell