Weltrend Semiconductor Inc.

Jeng-Cheng Liu

Ren-Yi Chen

Ming-Ying Kuo

Chun-Teh Chen

Mu-Chih Lin

Chih-Sheng Yang

Cheng-Liang Lin

A power delivery system includes a power sourcing equipment, a powered device and a transmission cable. When the power sourcing equipment is electrically connected to the powered device via the transmission cable, an over-current detecting circuit in the power sourcing equipment is configured to detect over-current occurrence of the powered device. Meanwhile, the power sourcing equipment is configured to determine the functionality of the over-current detecting circuit based on its specific pin and provide single fault protection when the over-current detecting circuit fails.

Power delivery system and related method of detecting overcurrent and failure

A control method is introduced to operate an ACF power converter under a non-complimentary mode. A high-side switch is turned ON at least twice within a switching cycle of a low-side switch, to provide at least two high-side ON times. One of the high-side ON times follows the end of demagnetization time of a transformer in the ACF power converter, and the other follows the end of the blanking time that controls the maximum switching frequency of the low-side switch.

Control method in use of active-clamp flyback power converter

A control circuit includes a first control unit, a power unit, a driver unit, a second control unit, a power source, a first switch, a pull-up element and a second switch. The first control unit is used to detect whether a configuration channel line has a predetermined divided voltage and generate a control signal accordingly. The power unit is coupled to the configuration channel line and a power line for supplying power to the driver unit. The driver unit is used to enable or disable a light emitting unit according to the control signal. The second control unit is used to detect whether the configuration channel line has the predetermined divided voltage and control the first switch and the second switch accordingly. The first switch is coupled between a power source and the configuration channel line. The second switch is coupled between the pull-up element and the configuration channel line.

Growing community of inventors

Hsinchu, Taiwan

Jeng-Cheng Liu