Lutron Electronics Company, Inc.

Lutron Technology Company LLC

Jecko Arakkal

Mark Stephen Taipale

Venkatesh Chitta

Dragan Veskovic

Brent M Gawrys

Mark Charles Fischer

David E Cottongim

Russell Lawrence MacAdam

Andrew Ryan Offenbacher

David E Cottingim

The output current of a ballast is dynamically limited when an over-temperature condition is detected in the ballast according to one of (i) a step function or (ii) a combination of step and continuous functions, so as to reduce the temperature of the ballast while continuing to operate it.

Thermal foldback for a lamp control device

An electronic dimming ballast comprises a filament turn-off circuit for controlling the magnitudes of filament voltages supplied to the filaments of a gas discharge lamp. Each of a plurality of filament windings is directly coupled to one of the filaments and is operable to supply a small AC filament voltage to the filaments. The plurality of filament windings and a control winding are loosely magnetically coupled to a resonant inductor of an output circuit of the ballast. A controllably conductive device is coupled across the control winding. When the controllably conductive device is conductive, the voltage across the control winding and the filament windings falls to zero volts. The controllably conductive device is driven with a pulse-width modulated (PWM) signal so as to control the magnitudes of the filament voltages. The filament voltages are provided to the filaments before striking the lamp, and when dimming the lamp near low end.

Apparatus and method for controlling the filament voltage in an electronic dimming ballast

Thermal protection for lamp ballasts

The operating frequency of a ballast is sufficiently far from resonance that, when a compact fluorescent lamp is dimmed to about one percent light output level, the ballast is operating with an open loop gain below a predetermined level, such as, for example, 15, and is operating with an output impedance greater than a predetermined level, such as, for example, the absolute value of the maximum negative incremental impedance of the lamp, and more preferably, greater than twice the absolute value of the maximum negative incremental impedance of the lamp. By changing the frequency to 85 kHz from 80 kHz, for example, the gain is maintained about the same whether the light output is at five percent or one percent, for example. This provides a stable control loop. In this manner, compact fluorescent lamps can be dimmed below about one percent light output, without dropping out and without observable flicker.

Electronic dimming ballast for compact fluorescent lamps

Growing community of inventors

Emmaus, PA, United States of America

Jecko Arakkal