Nordson Corporation

Jeanne Marie Leidy

William Mark Rucki

Joseph G Schroeder

Gerald W Crum

Eddie W Dixson, Jr

Cynthia A Skelton-Becker

Charles L Gatian, Iii

Dale N Gimben

Jeffrey Heimburger

A powder coating control system comprising a plurality of gun controls associated with a like plurality of powder spray guns. Each of the gun controls stores a plurality of presets spray parameters. Each of the gun controls responds to part identification signals and part position signals to select in real time one of the stored presets of spray parameters and trigger its respective powder spray gun ON and OFF to apply a powder coating to the moving part in accordance with the selected set of spray parameters. The control system further permits a gun purge cycle to be programmed either before or after the powder coating process is executed. The control system automatically initializes and brings each of the gun controls to an operable state on-line with the system control.

Distributed control system for powder coating system

A powder spray coating system has a controller configurable to a variety of different system configurations. Configuration data is keyed by an operator from menu prompts and stored for use by a microprocessor based operating program to operate the supply of powder and air to a powder spray gun. The microprocessor also presents information from monitored parameters of the system, including the supply air dew point which is monitored to provide warning signals of potential condensation in the system. Dew point detection is accomplished by measuring temperature and relative humidity and comparing the measurements with values for air at the maximum acceptable dew point. Alternatively, measurement of absolute humidity and supply air pressure are used to compute the dew point of the air which is compared with the actual temperature and maximum dew point temperature.

Powder coating system with dew-point detection

Powder coating system with configurable controller and dew point

A foam material dispensing system is provided with a control which measures the amount of high viscosity liquid material delivered to a mixer, determines the amount of pressurized gas required to be injected into the mixer in order to produce a foamable material with a desired gas concentration, measures the amount of gas actually delivered to the mixer, and generates a cumulative error signal representing the difference between the required amount of gas and the gas actually delivered. A control signal is generated to regulate the flow of gas to the mixer in relation to the magnitude of the error signal. A digital flow meter generates a pulse for each incremental amount of liquid material delivered to the mixer during an interval of time. During each successive interval, the pulses are counted and the count is multiplied by a preset gas-to-material ratio, from which the measured gas flow is subtracted and the difference added to the cumulative error term. The error term is combined with a term proportional to the amount of liquid material delivered over a predetermined number of successive time intervals to produce the control signal.

Method and apparatus for controlling the gas content of foam materials

Growing community of inventors

Rocky River, OH, United States of America

Jeanne Marie Leidy