Continental Automotive Gmbh

Continental Automotive France

Vitesco Technologies Gmbh

Jean-Luc Fremaux

Philippe Serrecchia

Jerome Dileon

A method for compensating for a temperature drift of an accelerometer for measuring the lateral tilt of a motorbike. When the vehicle is in the 'bike upright' condition, and the temperature of the accelerometer is at least 30&#xb0; C. above its reference temperature, a reading is taken of the acceleration values. These values are then processed in order to identify the coefficient of the slope of the straight line for correcting the offset of each axis of the accelerometer. A processing operation involves verifying the strict monotony of the coefficients in at least two successive readings and ensuring that the mean value thereof is included between determined limits. The mean coefficient that is finally obtained then can be used to correct the temperature of accelerations read over the entire operating range of the accelerometer. Thus, the computation of the tilt angle of the motorbike is more precise.

Compensating the temperature drift of an accelerometer on board a two-wheeled motor vehicle for measuring vehicle tilt

In a method of cleaning injectors of a direct-injection controlled-ignition engine, while idling, maximum fuel pressure to be injected for cleaning is calculated, by executing for at least one predetermined engine operating speed an iterative loop. During each loop the injected fuel pressure value increases and the injection time corresponding to the increased pressure is determined, selecting for each operating speed a cleaning pressure equal either to the maximum fuel pressure to which an injection time greater than the calibrated minimum injection time determined for the operating speed corresponds or to a maximum limit pressure corresponding to a given calibrated pressure for the engine/injectors system. Secondly, a cleaning treatment includes selecting an operating speed allowing the maximum cleaning pressure and controlling an engine operation by applying this speed and programming the cleaning pressure over a treatment duration exceeding the operating time allowed while running under operating conditions of this kind.

Method for cleaning injectors of a direct-injection controlled-ignition engine

This method of injection management in a direct-injection engine involves shifting from a so-called single-injection mode (Init 1 pulse), in which the major portion of the quantity of fuel injected during a combustion cycle is injected in one go, to a so-called multi-injection mode (MPL active), in which several successive injections are carried out in order to inject fuel during a combustion cycle, and vice versa. The multi-injection mode is chosen when a condition based on one or more parameter(s) of the engine is fulfilled (MPL cdn ok). The multi-injection mode is limited to a predefined time interval (Tact_MPL_max) even if, at the end of the interval, the condition for adopting the multi-injection mode is still fulfilled.

Growing community of inventors

Toulouse, France

Jean-Luc Fremaux