Bloom Energy Corporation

Jayanth Moodliar

Ranganathan Gurunathan

Prasad Pmsvvsv

Vishal Anand Gopalakrishnan

Ali Zargari

Deepak Balakrishnan

Mehdi Ebad

Rakesh Kumar Roy

Aditi Akula

Vishal Anand Ag

Saravana Narayanasamy

A microgrid includes a power system configured to output system power and an automatic transfer switch (ATS). The ATS includes a normal terminal that is electrically connected to a grid power line configured to receive grid power from a power utility, an emergency terminal that is electrically connected to a system power line configured to receive system power from the power system, and a load terminal that is electrically connected to a critical load line configured to provide power to a critical load. The microgrid also includes a bypass line electrically connected to the system power line and the critical load line, so as to bypass the ATS, and a circuit breaker configured to control power flow through the bypass line.

Microgrid including dual mode microgrid inverter and load management method

Systems, methods, and devices of the various embodiments may provide for the selective enablement and disablement of tags, such as control/process tags, in controller area network (CAN) networks, such as power generation systems, including fuel cell systems connected by a CAN bus. The selective enablement and disablement of tags, such as control/process tags, according to the various embodiments may enable management of CAN traffic such that CAN bandwidth may not be exceeded in CAN networks, such as fuel cell systems connected by a CAN bus.

Method and apparatus for handling controller area network (CAN) messages in a fuel cell system

Methods, systems and devices for remotely updating software installed on a digital signal processor (DSP) without setting the mode select pins on the DSP control card. Firmware configured to suspend operations upon receiving a programming signal is installed on the processor. A controlling computing device send the programming signal, causing the processor to halt execution, erase portions of the firmware, set an update firmware flag, and send control signals to the controlling computing device. The remote computing device sends updated firmware and an application program cyclic redundancy check to the processor. The processor compares a cyclic redundancy check of an on-chip flash memory with the received application program cyclic redundancy check. If the two match, the processor installs the received firmware, unsets the update firmware flag, and restarts itself.

Programming processors through CAN interface without changing the boot mode select pins

Growing community of inventors

Bengaluru, India

Jayanth Moodliar