Eastman-kodak Company

Jay D Frazier

Kenneth J West

Meagan A Wimmers

David A Huliba

Bruce A Bowling

Charles D Rike

An automatic start-up for a continuous ink jet printer provides a dyeless flush fluid to the printhead to remove any particles or ink residue from the printhead and to wet the orifice plate before jets form. The pressure of the flush fluid is then raised to cause the flush fluid to begin jetting from the drop generator. Once jets are established, ink is supplied to the drop generator at the pressure of the jetting flush fluid. The flow of flush fluid is stopped. Since the printhead is being supplied with ink, ink replaces the flush fluid as the fluid being jetted from the drop generator. An ink heater is then turned on, increasing evaporation of solvent from the ink jetted from the drop generator. The solvent vapors condense on the relatively cool charge plate and catcher face. The condensate forming on these surfaces provides one final rinse of these surfaces to remove conductive ink from the charge leads and catcher face. After a period of condensate cleaning, the ink heater is turned off, and a heater attached to the charge plate catcher assembly is turned on to dry the charge plate and catcher. Charge voltage may then be turned on to deflect the ink drops into catch. At this point, the printhead is ready for printing.

Automatic startup for a solvent ink printing system

A shutdown procedure is provided for removing all solvent ink from the printhead of an ink jet printer system that uses volatile ink for printing a shutdown method is provided for an inkjet printer that uses volatile inks for printing. Initially, a colorless flush fluid is provided which readily dissolves the ink. The flush fluid is crossflushed through the drop generator and caused to weep out of the orifices in the drop generator to dissolve and rinse away ink residues from the charge plate and the exterior of the orifice plate. The flush fluid is used to rinse off charging electrodes of the charge plate, the catcher face, and the catcher return line. Fluid crossflushed through the drop generator cleans the interior of the drop generator and cleans the crossflush valve.

Purge shutdown for a solvent ink printing system

A catcher design is provided wherein vacuum channels are added to both sides of the catcher to remove ink from the face of the catcher and from the eyelid seal. An additional fluid port on the catcher allows the additional vacuum channels to maintain an increased level of vacuum. A restriction on the catcher line balances the fluid flow between the catcher and the additional vacuum channels. A scoop can be machined into the catch pan to remove fluid from below the catcher face. A manifold can be used to maintain a vacuum source for the catcher throat and the additional channels, while pulling the unprinted ink back to the fluid system. Finally, a wider eyelid seal can allow purge fluid used during shutdown to clear the channels.

Anti-wicking catcher arrangement for a solvent ink printhead

A shutdown procedure is provided for removing all solvent ink from the printhead of an ink jet printer system that uses volatile ink for printing. A shutdown method is provided for an inkjet printer that uses volatile inks for printing. Initially, a colorless flush fluid is provided which readily dissolves the ink. The flush fluid is crossflushed through the drop generator and caused to weep out of the orifices in the drop generator to dissolve and rinse away ink residues from the charge plate and the exterior of the orifice plate. The flush fluid is used to rinse off charging electrodes of the charge plate, the catcher face, and the catcher return line. Fluid crossflushed through the drop generator cleans the interior of the drop generator and cleans the crossflush valve.

Growing community of inventors

Jamestown, OH, United States of America

Jay D Frazier