Chrysler Group LLC

Chrysler Corporation

Daimlerchrysler Corporation

Javed Dada

Hussein A Dourra

Ali M Mourtada

Teddy Siy

Bruce K Geist

John W Degeorge

John M Rzepecki, Ii

Pradeep Attibele

Gary K Lowe

William F Resh

David Parenti

Gary Binienda

Peter G Hartman

Michael J McNeil

Brandon Brigham

Harish Sivasubramanian

Alexander Dolpp

Nathan Hosler

A method of performing a double swap kickdown shift in a transmission having a main box and a compounder. The compounder is shifted during the hold speed phase of the downshift. The target ratio for the downshift is overshot by an overshoot RPM.

Double swap kickdown shift control

A system for controlling a torque converter clutch in a vehicle powertrain includes a controller having an input for receiving powertrain operating parameter information. The controller is configured to determine a torque converter speed ratio based on the powertrain operating parameter information and to compare the speed ratio to a specified speed ratio limit. The controller is further configured to determine a target torque converter slip when the speed ratio exceeds or meets or exceeds the specified speed ratio limit; to compare the target slip with a desired slip value based on an vehicle noise, vibration or harshness (NVH) limit; and to control torque transmission of the torque converter clutch based on comparison of the target slip and the desired slip value. A method for controlling a torque converter clutch is also provided.

Torque converter clutch control

An automatic transmission for a vehicle includes a main box controlled using a series of clutches, and an underdrive assembly controlled using a series of clutches and at least one overrunning clutch. In achieving a double-swap downshift from a first transmission 'gear' employing a first main box clutch and a first underdrive assembly clutch, to a second transmission 'gear' employing a second main box clutch and a second underdrive assembly clutch, a controller delays release of the first main box clutch until after the second underdrive assembly clutch has been prefilled, and fully applies the second underdrive assembly clutch only after slip has been detected in both the main box and the underdrive assembly. Additionally, the controller fully applies the second main box clutch only after the second underdrive assembly clutch has itself been fully applied.

Transmission downshift swap-shift control

Automated calibration of an automatic transmission design generates upshift scheduling curves in a throttle level/transmission output speed plane based upon laboratory-generated data and user generated drivability data. Downshift scheduling curves and torque converter lock-up and unlock curves are then generated as offsets from breakpoints on corresponding upshift curves, the offsets determined principally from the drivability data.

Automatic transmission calibration method

An automatic transmission for a vehicle includes a multi-plate clutch having an applied state and a released state and an overrunning clutch having an engaged state and an overrunning state. In addition, the transmission includes a controller that effectuates a gear shift of the transmission by applying a volume of fluid to the multi-plate clutch to toggle the multi-plate clutch from the released state to the applied state at approximately the same time the overrunning clutch is toggled into the overrunning state. The applied volume of fluid at which the multi-plate clutch is applied is substantially given by the following equation:&#x2212;()

Up shift control with overrunning clutch

A turbine acceleration control system for a transmission in a vehicle determines a desired turbine acceleration based on a downshift type and an altitude of the vehicle. The turbine acceleration control system determines a downshift type that results from one of a throttle increase, a manual downshift, or vehicle deceleration. An altitude module determines an altitude of the vehicle. A vehicle controller communicates with one or more lookup tables to determine the desired turbine acceleration based on the downshift type and the altitude. Additionally, current turbine speed and torque converter slip are considered by the controller in determining the desired turbine acceleration.

Downshift acceleration control

Growing community of inventors

Lapeer, MI, United States of America

Javed Dada