General Electric Company

Battelle Memorial Institute

Ge Corporate Financial Services, Inc.

Jason Wayne Black

Eric L Rehberg

Rajesh Tyagi

Jason J McCullough

Jason Mccullough

Eric Rehberg

James E Dvorsky

Seyed A Mansouri

Bradley Charles Glenn

Harjeet Johal

Ronald Ray Larson

Douglas Anthony Thornton

Xiaofeng Wang

John Andrew Ellis

Matthew Christian Nielsen

Rajesh Venkat Subbu

Rayette Ann Fisher

Reigh Allen Walling

David Joseph Najewicz

Sahika Genc

Michael Joseph Krok

James Joseph Schmid

James Henry Saunders

William Jerome Burke

Bex George Thomas

Kete Chalermkraivuth

Ming Cheng Li

Weiwei Chen

Jayanth Kalle Marasanapalle

Augusto Ramon Sellhorn

Bethany Hoogs

Lauren Adams

Murali Mohan Baggu Data Venkata Satya

Sean Coleman Keenan

Radu Neagu

Jingjiao Zhang

David Chienju Li

Prasoon Tiwari

Kannan Natarajan Tinnium

Zhenhua Jiang

Yi Zhang

Devon Leigh Manz

Vishwanath Avasarala

James H Saunders

An aggregation comprises: loads that draw electricity, and a hierarchy including a root dispatch engine at the top of the hierarchy, downstream dispatch engines each servicing downstream points comprising further downstream dispatch engines or loads, and the loads at the bottom of the hierarchy. Each downstream dispatch engine sends draw dispatches to its downstream points such that the total draw computed by summing the draw dispatches equals a draw dispatch received by the downstream dispatch engine from the dispatch engine above it in the hierarchy. The sent draw dispatches also satisfy downstream point draw constraints communicated to the downstream dispatch engine from its downstream points. In a method, a baseline long-term draw dispatch is determined for the aggregation, and the baseline long-term draw dispatch is modulated over a shorter time interval based on a short-term draw requirement to determine a draw dispatch for the aggregation.

Hierarchical operational control of aggregated load management resources

In a direct load control system supporting frequency control of an electrical grid, at each electrical load of an aggregation of loads, a load status report is generated comprising an urgency value and a power level. At an aggregation dispatch controller, a dispatch signal is generated based on the generated load status reports and information indicative of electrical frequency. At each electrical load of the aggregation, the load is operated at the reported power level if the reported urgency value satisfies the dispatch signal and is not operated at the reported power level if the reported urgency value does not satisfy the dispatch signal.

Method and system for using demand side resources to provide frequency regulation using a dynamic allocation of energy resources

A water heater that includes a cylindrical storage tank, at least one heating element, and at least one temperature sensor is modeled using a one-dimensional model that includes: a vertical stack of disks representing the water volume in the cylindrical storage tank, and a stack of annular segments surrounding the vertical stack of disks. The stack of annular segments represents the cylindrical wall of the cylindrical storage tank. The one-dimensional model may be used by a condition-based maintenance system comprising an electronic data processing device configured to detect a failure mode present in the water heater based on an output of the water heating model component. Some illustrative failure modes include insulation disturbance, heating element failure, excessive sediment buildup, or a drip tube rupture.

Estimation of unknown states for an electric water heater with thermal stratification and use of same in demand response and condition-based maintenance

In a direct load control system supporting frequency control of an electrical grid, loads are grouped into a plurality of load aggregations based on electrical power draw characteristics of the loads, e.g. power draw magnitude characteristic and transient slew rate. A best-fit dispatch signal is generated for each load aggregation to match a desired load response with a sum of predicted load responses of the aggregations each operating in accord with its best-fit dispatch signal. For each load aggregation, its best-fit dispatch signal is communicated to the loads of the load aggregation, and the loads of the load aggregation are operated in accord with the best-fit dispatch signal communicated to the loads. The desired load response may be generated based on historical Automatic Generation Control (AGC) signal data and at least one of (1) a weather forecast and (2) daily, weekly, and seasonal cycles.

In a frequency control system, a system controller assigns load-specific threshold frequencies to electrical loads of a fleet of electrical loads. Load controllers perform load monitoring and control operations for controlled electrical loads of the fleet including (i) comparing a measurement of the electrical frequency with the threshold frequency assigned to the controlled electrical load and (ii) operating the controlled electrical load based on the comparison. For example, each load controller may perform operation (ii) by turning the controlled electrical load on if the measurement of the electrical frequency is greater than the threshold frequency assigned to the controlled electrical load, and turning the controlled electrical load off if the measurement of the electrical frequency is less than the threshold frequency assigned to the controlled electrical load. The threshold frequencies may be assigned based on State of Charge (SOC) values for the loads.

Primary frequency control through simulated droop control with electric loads

Loads on a distribution circuit are operated, which causes the loads to consume electricity delivered to the loads via the distribution circuit. A circuit voltage of the distribution circuit is measured. An excursion of the measured circuit voltage outside of a normal operating voltage range is responded to by triggering a sub-set of the loads on the distribution circuit to increase or decrease their power draw to counter the excursion. For an overvoltage condition, the responding comprises triggering a sub-set of the loads on the distribution circuit to operate, or increase their power draw, in order to reduce the circuit voltage. For an undervoltage condition, the responding comprises triggering a sub-set of the loads on the distribution circuit to cease operating, or reduce their power draw, in order to increase the circuit voltage.

Automated voltage support from load resources

An electric water heater that includes a thermostat is retrofitted for remote control as follows. A relay is installed on an electrical feed to the electric water heater. Water temperature and electric current or power through the electrical feed are measured over time with the relay closed, and the thermostat deadband maximum and minimum are detected as the water temperature at which the thermostat turns the heating element off, and the water temperature at which the thermostat turns the heating element on, respectively. The detected thermostat deadband maximum and minimum are stored as load controller deadband maximum and minimum, respectively. The thermostat set point is raised, and the electric water heater is thereafter controlled using the load controller by operations including closing the relay when the water temperature falls below the load controller deadband minimum and opening the relay when the water temperature rises above the load controller deadband maximum.

Automatic set point detection for water heaters operating in a demand response

A plurality of interactive electrical loads defines an aggregation connected with an electrical power grid. A scheduler generates a baseline power consumption schedule for the aggregation, determines frequency regulation capacity of the aggregation, and controls actual power consumption of the aggregation based on the baseline power consumption and an Automated Generation Control (AGC) signal of the electrical power grid to operate the aggregation as an ancillary frequency control device of the electrical power grid with the determined frequency regulation capacity. The controlling may comprise generating baseline dispatch signals for implementing the baseline consumption schedule, adjusting the baseline dispatch signals based on the AGC signal to generate adjusted dispatch signals, transmitting the adjusted dispatch signals to the plurality of interactive electrical loads defining the aggregation, and generating an AGC response log based on differences between the adjusted dispatch signals and the baseline dispatch signals.

Direct load control frequency regulation support system

Using demand side resources to provide frequency regulation

A method and system for controlling demand events in a utility network with multiple customer sites. The value of a demand response parameter threshold for invoking a demand response event is calculated based on the number of available demand response events and the number of opportunities remaining to issue the available demand response events. This parameter represents the utility objectives for using the demand response program (e.g., cost savings, reliability, avoided costs). A current value of the demand response parameter is compared to the threshold value, and a determination is made whether or not to call a demand response event for the current opportunity, or to save the event for a future opportunity based upon this comparison.

Method and system for demand response management in a network

Method and system to provide co-optimized utilization of demand response and energy storage resources in an electrical grid system. The system may include a module to evaluate a marginal savings relative to a dispatch cost, if a demand response event is performed. The system may further include a module to evaluate a marginal savings relative to the dispatch cost, if an energy storage event is performed, and a controller including circuitry may be configured to determine a control strategy to perform a dispatch including a demand response event and/or an energy storage event, based at least in part on the respective marginal savings of the demand response event and/or the energy storage event, which may be selected to co-optimize an integrated utilization of the demand response and energy storage resources to meet a given objective.

Method and system to co-optimize utilization of demand response and energy storage resources

A method for providing VAR support in a power distribution network having a demand response management system can include querying the demand response management system for an inductive device on the power distribution network and power cycling the inductive device to effect reactive power in the power distribution network.

Demand response management system and method with VAR support

A method includes receiving at least one event parameter for a demand response event and identifying a pool of customers. The pool of customers includes a plurality of customers potentially usable to support the demand response event. Characteristics of each customer in the pool of customers are retrieved and a plurality of groups of customers are created from the pool of customers based on the retrieved characteristics and the at least one event parameter.

Systems and methods to aggregate loads for demand response events

A phase balancing system includes a load forecasting module, a phase unbalance identification module and a demand response module. The load forecasting module determines a load forecast for the distribution system for the period of interest and the phase unbalance identification module determines voltage unbalance on the distribution system for the period of interest. The demand response module estimates an available demand response on the distribution system for the period of interest and allocates an optimized demand response from the available demand response to minimize the voltage unbalance on the distribution system for the period of interest.

System and method for phase balancing in a power distribution system

Growing community of inventors

Dublin, OH, United States of America

Jason Wayne Black